Buggies Gone Wild Golf Cart Forum

Buggies Gone Wild Golf Cart Forum (http://www.buggiesgonewild.com/)
-   Electric Club Car (http://www.buggiesgonewild.com/electric-club-car/)
-   -   Need general "getting started" info on 96 CC... (http://www.buggiesgonewild.com/electric-club-car/41442-general-getting-started-info-96-cc.html)

ccstretch 11-24-2010 09:59 PM

Need general "getting started" info on 96 CC...
 
I bought our first cart about 2 months ago... and now I am completely hooked on carting! I never would have thought...

I have been able to determine that my cart is a 1996 CC DS Electric (48v)... it is lifted with 22 inch tires - it was used a Golf Course (still has numbers on the front) but don't know anything else - and am not sure where to start. I've gone over the cart looking for clues as to what I have plus I've been pouring over this forum trying to figure out what is what.

I've seen posts about:
- "regen" (but not sure if my cart is one of these)
- 400 - 500 amp controllers (Alltrax and PQ) - but don't know which I have presently
- soleniods (by the way, is it possible that I have 2 soleniods as at first glance it seems that way).

I want to make sure I am maintaining the cart correctly, and I'm itching to do some speed/torgue upgrades. But I need to know exactly what I have before I can start. Should I try to locate an Owners Manual or something? Where to start?

Any help in how I can learn what I have here would be much appreciated!

http://localwisemedia.s3.amazonaws.com/1a.jpg

http://localwisemedia.s3.amazonaws.com/3a.jpg

ccstretch 11-24-2010 10:41 PM

Re: Need general "getting started" info on 96 CC...
 
OK... just ran across a post with a link to a wiring diagram that looks closer to my cart (ie 2 soleniods): http://www.golfcartpartsdirect.com/e...tshow/211.html

The poster said he had a 96 Powerdrive Plus 48V - how can I determine if my cart is a Powerdrive Plus?

My cart is s/n A9634-520662

Thanks again and especially for patience as I ramp up!

physcoflip 11-24-2010 10:53 PM

Re: Need general "getting started" info on 96 CC...
 
I am no expert but one of them will probably answer you soon. They probably will need to know what type of f/r switch you have. The one between the seats or on the dash. How many batteries do you have? 6 8volt, or 6 6 volt?

physcoflip 11-24-2010 11:02 PM

Re: Need general "getting started" info on 96 CC...
 
I only see one wiring diagram in the stickies for your year DS. So it is most likely a 48volt cart. I don't know what to look for to recognize if it is a regen cart though. The real question is if your diagram doesn't match the one in the stickies is if your cart was already upgraded with a controller and what not.

OLD MEC 11-25-2010 10:26 AM

Re: Need general "getting started" info on 96 CC...
 
I would get your self a service manual as it WILL save you time and money in long run.
If you have a lever under your right leg you have a series cart, and if you have a rocker type switch under your leg its a Regen-1 cart which would accounts for 2 solenoids.
Stock your cart came with a Curtis 250-275 amp controller and about a 3 Hp motor. In 1995-1997 CC used several different pot units ( throttle pedal speed controls ) and some are no longer availible, so you may depending on pedal castings ( 2 types used ) may when needed convert to modern MCOR control, or a Curtis PB-6 unit?
I would start with minimum of 4 guage multi strand welding cable cables through out ( battery-motor-F&r-etc ) to help with lost power because of lift and larger diameter tires.
Then when funds are available you might consider a higher amp controller 300-400-500 and possible motor HP update? I personally like Alltrax controllers and there are several different very good motor suppliers available. When picking motors-controllers combinations always give all information about lift, tire size, cable size, extra weight like rear seat and HD springs and future plans for cart to get best combination of performance available.
AND BY ALL MEANS USE OUR FORUM SPONSORS.

ccstretch 11-25-2010 09:42 PM

Re: Need general "getting started" info on 96 CC...
 
PHYCOFLIP - My cart has 6 batteries: Trojan T-875 Milage Master. Looks like from what I can see on the web that these are 8v. Also, this is the link I found on another post that looks more like my woring diagram then anything I saw on the stickys:

http://www.golfcartpartsdirect.com/e...tshow/211.html

Also, my cart has a ROCKER type f/r switch, and following OLC MEC's reply it must be a Regen 1 as it does have the 2 soleniods like the diagram.

OLD MEC - I will definately buy a service manual right away. Your advice on where to get one?

Next I'll move to the cables you suggested - something my son and I can do together this winter. I'll log your other advice for when the funds are available.

Is there any need for me to determine if the cart is a "Powerdrive Plus" (see my other post above)?

I am thankful for both of your responses and input - and I appreciate the patience you both are showing with a real greenhorn! Let me know anything else you can think of...

ccstretch 11-25-2010 10:49 PM

Re: Need general "getting started" info on 96 CC...
 
OLD MEC: After reading your message and reading some more posts I have a question:

Do you think I need to go with the 2 gauge cables (vs 4 gauge) since my cart is lifted, 22 in tires, rear seat etc. - as I do plan on upgrading the controller and motor this spring (assuming by your post that HP = horsepower) ?

I hope this is not a dumb question - still trying to get my bearings on all this.

OLD MEC 11-26-2010 10:40 AM

Re: Need general "getting started" info on 96 CC...
 
THERE ARE NO DUMB QUESTIONS ONLY DUMB IF UNASKED. Thats how we all learn and I am told when you stop you might as well be dead????
You are correct "HP" is horse power
Your batterys are mid amp range for 8 volt batterys ( same as I use in my own cart now over 9 years old and still going good even though I have much heavier body than stock )
Manuals-I would check with forum sponsors first and then if not avaliable check forums for sale site or some thing like Ebay. On your year it may require a 1995 manual with 1996 update manual as well? I see more this way than just 1996 regular single manuals.
Charger-All same for the years from about 1995 to 2005 model CC part number 101802201. My 1996 is CC-Lester Model #17930.
Battery cables-I use a rule of thumb that seems to work out for me? Controllers from 275to 300 amps I use 4 guage. Controllers from 400 to 500 I use 2 guage. Controllers from 500 and up I use 1 guage.
Be sure to give the needed info shown in previous posts when checking on which controller and motor combo to use and then you can pick correct guage wiring to use. Dont get horse before cart so to speak?

scottyb 11-26-2010 10:47 AM

Re: Need general "getting started" info on 96 CC...
 
2g cable for a 400 amp controller? Why?

easydoesit 11-26-2010 11:39 AM

Re: Need general "getting started" info on 96 CC...
 
I believe 4ga is good up to 400amps, 2ga up to 500amps


All times are GMT -5. The time now is 09:25 PM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. 2006-2017 Buggiesgonewild.com. All rights reserved.