Lights wiring issue 2002 club car ds

med_11

Guys sorry for keeping with the questions, I decided to start a fresh knew post,

I already tried to search the forums but no luck,

My cart is a 2002 club car ds

I have a question the cart had front headlights when I got it I added 2 tail lights I wired all the positives together and all the negatives together which are wired to the original cables that were on the battery and hooked up to the aux switch.

Now when the switch is on the on position all lights work, when I switch it to off position safety fuse blows..

Originally with headlights only it had a 15amp fuse now that I have head & tail lights do I need a higher amperage so that it does not blow??

I tried running direct with no fuse,

What happens is it works but when I turn the switch of it sparks the wires and looks like it will burn if I don't remOve,

What do you guys think I need to do????

Could I have them mix up only two are connected power and ground..???

Also where is the 12v connection on this cart?

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

shadowman

you have to have a voltage reducer to get to 12 volts if the cart dosn,t have one.....if wires from lights are running to batteries they might be running off of 16 volts.....grab a meter and test where lights are wired.................

med_11

Shadowman your fast lol

Ok I'll check, but trying to not get into a reducer,

Is there any chance the cart has a 12v hook up?

What's weird is that the headlights worked perfect on the exact connection it was only until I put in the two rear lights I started to have the issue with fuse and wire smoking,

shadowman

try disconnecting the lights you hooked up see if that helps, if i,m not mistaken i think but i could be wrong that the keyswitches are 12 volt even though they sell them voltage specific but wait for someone who knows more about them......other than that if theres no voltage recucer than theres no 12 volt anywhere..............................

med_11

oK ISSUES HAS BEEN FIXED,

what happened was that the swtich was not plugged in properly,

it had a ground, a main positive and a positive for acc.

i had all but the acc positive hooked up, and keep blowing,

i reconnected as instructed and no all works fine!

thanks to SHADOWMAN, SCOTTYB and all the other members who chimed in to assist,

its very much appreciated, i hope to be as helpful to other members when i have the oppurtunity.

shadowman

your welcome..........................