lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car
Electric Club Car Electric DS, and Precedent golf cars



Post New Thread  Reply
Thread Tools Display Modes
Unread 05-20-2011, 11:23 PM   #11
Gone Wild
Club Car
 
Join Date: Apr 2011
Location: Texas
Posts: 600
Default Re: HELP!! Key switch off but still goes FWD and RV

I downloaded the software last week and was able to connect to my 06 precedent this was 1 of the things that could be set it's free
gaminde is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 05-21-2011, 12:58 PM   #12
Dawg Gone Wild
 
TahoeDawgZ71's Avatar
Club Car
 
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 7,977
Default Re: HELP!! Key switch off but still goes FWD and RV

Quote:
Originally Posted by gaminde View Post
I downloaded the software last week and was able to connect to my 06 precedent this was 1 of the things that could be set it's free
Where'd ya get that? I'd be interested in having that personally.
TahoeDawgZ71 is offline   Reply With Quote
Unread 05-21-2011, 01:08 PM   #13
Gone Wild
Club Car
 
Join Date: Apr 2011
Location: Texas
Posts: 600
Default Re: HELP!! Key switch off but still goes FWD and RV

I will upload to my web site today will post when done
gaminde is offline   Reply With Quote
Unread 05-21-2011, 02:04 PM   #14
Gone Wild
Club Car
 
Join Date: Apr 2011
Location: Texas
Posts: 600
Default Re: HELP!! Key switch off but still goes FWD and RV

Curtis Programming software

http://gaminde.net/SCS/Club_Car/Curt...ng_station.zip
gaminde is offline   Reply With Quote
Unread 05-25-2011, 03:41 PM   #15
Dawg Gone Wild
 
TahoeDawgZ71's Avatar
Club Car
 
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 7,977
Default Re: HELP!! Key switch off but still goes FWD and RV

Quote:
Originally Posted by gaminde View Post
Very nice... what kind of cable setup are you using to communicate with the controller?
TahoeDawgZ71 is offline   Reply With Quote
Unread 05-25-2011, 08:45 PM   #16
Gone Wild
Club Car
 
Join Date: Apr 2011
Location: Texas
Posts: 600
Default Re: HELP!! Key switch off but still goes FWD and RV

David after trying for hours to get the software to work I found my diagnostic connector rusted out guess I should Have looked up while laying on the floor.

So I cut it out and installed a earphone jack, (stereo) This is what I had used on a microcontroller project and already had DB9 to Stereo Plug harness made up.

After running the program and watching the serial port, I think I will be able to make a microcontroller interface for the Curtis Controller. I think I can make a reader to monitor the state of the sensors, bat voltage controller output and much more, which would make it much easier for people to work on there units.

I have done some programming of the controller using a terminal program like mode 1 through 3, this worked great, I have programmed mode 4 into the controller, it took it but the speed did not change??? guess I need code a,b and c.

Now as far as connectors Were can I get the diagnostic connector both male and female if this is to much then I will use the molex connector on the Curtis controller guess I need to do some research.
gaminde is offline   Reply With Quote
Unread 05-25-2011, 09:21 PM   #17
Dawg Gone Wild
 
TahoeDawgZ71's Avatar
Club Car
 
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 7,977
Default Re: HELP!! Key switch off but still goes FWD and RV

Quote:
Originally Posted by gaminde View Post
David after trying for hours to get the software to work I found my diagnostic connector rusted out guess I should Have looked up while laying on the floor.

So I cut it out and installed a earphone jack, (stereo) This is what I had used on a microcontroller project and already had DB9 to Stereo Plug harness made up.

After running the program and watching the serial port, I think I will be able to make a microcontroller interface for the Curtis Controller. I think I can make a reader to monitor the state of the sensors, bat voltage controller output and much more, which would make it much easier for people to work on there units.

I have done some programming of the controller using a terminal program like mode 1 through 3, this worked great, I have programmed mode 4 into the controller, it took it but the speed did not change??? guess I need code a,b and c.

Now as far as connectors Were can I get the diagnostic connector both male and female if this is to much then I will use the molex connector on the Curtis controller guess I need to do some research.
You're way over my head bro....... You lost me with the headphone jack. lol
TahoeDawgZ71 is offline   Reply With Quote
Unread 05-25-2011, 09:31 PM   #18
Gone Wild
Club Car
 
Join Date: Apr 2011
Location: Texas
Posts: 600
Default Re: HELP!! Key switch off but still goes FWD and RV

Sorry guess I got a little over excited !!!
gaminde is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
forward/reverse switch change to toggle switch Electric Club Car
Key switch & Kill switch question Gas Club Car
Forward Reverse switch limit switch Electric Club Car
Just got a G9 need to know how to wire ignition switch to push pull switch ASAP! Gas Yamaha
Micro switch on fwd and rev switch has bee removed Electric EZGO


All times are GMT -5. The time now is 08:02 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.