lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car
Electric Club Car Electric DS, and Precedent golf cars



Post New Thread  Reply
Thread Tools Display Modes
Unread 08-08-2011, 03:58 PM   #11
Not Yet Wild
 
medney's Avatar
Club Car
 
Join Date: Jul 2011
Location: North Carolina
Posts: 51
Default Re: Need Instructions to Bypass OBC Please

Thank you very much gentlemen!
medney is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 02-26-2013, 09:21 PM   #12
Gone Wild
 
Join Date: Jul 2012
Posts: 912
Default Re: Need Instructions to Bypass OBC Please

Yea but you should be able to bypass completely and junk the OBC, I think you have to loop a wire, the Dawg would know how.
Speedchaser is offline   Reply With Quote
Unread 02-26-2013, 09:33 PM   #13
Gone Wild
Club Car
 
Join Date: Feb 2010
Location: Florida
Posts: 184
Default Re: Need Instructions to Bypass OBC Please

Maybe this will help:

http://www.evdrives.com/v/images/Bat...ss_Diagram.pdf
jantrree is offline   Reply With Quote
Unread 02-28-2013, 08:04 PM   #14
Not Yet Wild
Club Car
 
Join Date: Nov 2012
Location: Houston, Texas
Posts: 46
Default Re: Need Instructions to Bypass OBC Please

Quote:
Originally Posted by cheapjeep2 View Post
Here is what you need to do.

On your wrench, tape up one end so all that is showing is the very end, that way if you drop it you don't short out a battery and cause it to blow up.

1. Move the Tow/Run Switch to Tow.
2. On the left most rear battery, drivers side (battery number 6) disconnect the Negative lead, from the pack, this is the wire that goes through the OBC.
3. On the right most, passenger side rear battery (battery number 1) disconnect the postive lead. that goes to the solenoid.

These steps will isolate the batteries from any components so you don't short out anything.

4. Run a new wire from the Negative post of battery number 6 to the charging receptacle and hook it up where the black wire is coming out. Basically Duplicate how it is done for the Red wire going to your positive on battery number one.

5. Put the main power wire back on the positive post that you took off on battery 1 and tighten securely.

6. Put the main negative wire back on the negative post of battery 6.

Move the Tow/Run switch back to Tow.

Plug in the charger and you should be good.

The OBC will still be in the power circuit (not charging) so it will reboot before your cart can run, basically turn the key on, put it in forward, tap the throttle, you'll hear the solenoid click, and the orange light on the dash will flash for a bit and go out.

You should be good to go then.
Is this for a regen 2 cart also? I removed the regen solenoid to put in an alltrax controller (per their directions).
plivanec is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
OBC Installation Instructions Electric Club Car
wanted instructions Golf Carts and Parts
Kingpin replacement no instructions?!?!94 G9 Gas Yamaha
motor instructions Gas Club Car
Yamaha Governor bypass Instructions for 1999 G-16 Gas Yamaha


All times are GMT -5. The time now is 10:16 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.