lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car
Electric Club Car Electric DS, and Precedent golf cars



Post New Thread  Reply
Thread Tools Display Modes
Unread 09-22-2011, 09:36 AM   #1
Not Yet Wild
 
Join Date: Jul 2010
Posts: 14
Default 1993 club car will not go

i have a 1993 36 volt club car with one solenoid that just stopped running
the solenoid has 36 volts to both large ends and ground to both small ends
it also has been replaced with a new club car solenoid help
TJWEST is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 09-22-2011, 09:47 AM   #2
Cartsunlimited.net
 
scottyb's Avatar
E-Z-GO
 
Join Date: Dec 2007
Location: Southern California
Posts: 64,086
Default Re: 1993 club car will not go

Quote:
Originally Posted by TJWEST View Post
i have a 1993 36 volt club car with one solenoid that just stopped running
the solenoid has 36 volts to both large ends and ground to both small ends
it also has been replaced with a new club car solenoid help
I think this is the problem, for test purposes, remove one of the small grounds and install a + jumper wire. The cart should run. No? try the removing the other ground wire and replace it.
You need one + and one - at the small posts to make the solenoid work & the cart run.
Let me know what happens.
scottyb is online now   Reply With Quote
Unread 09-22-2011, 10:11 AM   #3
Not Yet Wild
 
Join Date: Jul 2010
Posts: 14
Default Re: 1993 club car will not go

ok i removed the white and black wire and the red wire on the same small terminal these should give me power when the pedal is pressed? if i power that small terminal the solenoid clicks but the motor does nothing in f or r but i have 36 volts on both large terminals all the time
TJWEST is offline   Reply With Quote
Unread 09-22-2011, 10:15 AM   #4
Cartsunlimited.net
 
scottyb's Avatar
E-Z-GO
 
Join Date: Dec 2007
Location: Southern California
Posts: 64,086
Default Re: 1993 club car will not go

SO now you have power to Controller at B+ and B-? Is there also power at controller small spade #1?
scottyb is online now   Reply With Quote
Unread 09-22-2011, 10:30 AM   #5
The Last Moja Morani
 
shadowman's Avatar
Club Car
 
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
Default Re: 1993 club car will not go

i might be wrong but i don,t think the white, black and red wire should be mounted to the same terminal.........................................8 )
shadowman is offline   Reply With Quote
Unread 09-22-2011, 10:32 AM   #6
Not Yet Wild
 
Join Date: Jul 2010
Posts: 14
Default Re: 1993 club car will not go

i have power on both large terminals of solenoid and ground on both small terminals of solenoid the red wire on solenoid small terminal is going to the controller it has ground on it the small white and black wire that is with the red wire goes to the microswitch on the f&r lever this microswitch is dead and the microswitch on the pedal is dead
TJWEST is offline   Reply With Quote
Unread 09-22-2011, 10:37 AM   #7
The Last Moja Morani
 
shadowman's Avatar
Club Car
 
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
Default Re: 1993 club car will not go

how did this start? did it break down or did you get the cart this way? has anyone else worked on it? something with those small wires dosn,t seem right...there should be a small wire that runs off one of the large post over to V-glide............................................. ......
shadowman is offline   Reply With Quote
Unread 09-22-2011, 10:58 AM   #8
Not Yet Wild
 
Join Date: Jul 2010
Posts: 14
Default Re: 1993 club car will not go

the cart has had the solenoid removed before i got it but looking at the wiring diagram it looks ok it was running fine and just wont go anymore i am wondering if the controller is grounding the wrong wire or something also what are the jumpers on the solenoid resistors or diodes can they be bad
TJWEST is offline   Reply With Quote
Unread 09-22-2011, 11:04 AM   #9
Cartsunlimited.net
 
scottyb's Avatar
E-Z-GO
 
Join Date: Dec 2007
Location: Southern California
Posts: 64,086
Default Re: 1993 club car will not go

you have a - where you should have a +
Use you meter to test continuity and find where the wires in question go and what their function is.
Attached Images
File Type: jpg Resistor-&-Diode-instruction-web.jpg (170.6 KB, 10 views)
scottyb is online now   Reply With Quote
Unread 09-22-2011, 01:19 PM   #10
The Last Moja Morani
 
shadowman's Avatar
Club Car
 
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
Default Re: 1993 club car will not go

there should be a resistor and a diode and yes they can go bad.......also the diode goes on one way only......the silver band on it goes toward positive...................................
shadowman is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
1993 Club Car Help Electric Club Car
1993/'95 Club Car Electric Club Car
Wtb gas engine for 1993 club car Golf Carts and Parts
1993 Club Car - wants to keep running. Gas Club Car
1993 Club Car 36v Electric Club Car


All times are GMT -5. The time now is 12:51 PM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.