|
11-17-2011, 10:02 AM
|
#1 |
|
Not Yet Wild
Join Date: Nov 2011
Location: S. Georgia
Posts: 42
|
Wiring question
I have a 2005 DS IQ. I have been having an issue with very low speed. Looking at the cart today, I found that the red wire from the motor speed sensor is broken where it goes into the female connector. My question is: can I bypass the three pin plugs and wire directly until I can get new connectors?
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
11-17-2011, 10:09 AM
|
#2 |
|
The Last Moja Morani
 Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
|
Re: Wiring question
welcome, i don,t see why you can,t wire it directly bypassing the connector............
 |
|
|
|
|
11-19-2011, 11:23 PM
|
#3 |
|
Mr. Helper
Join Date: May 2009
Location: NY Catskills & South carolina
Posts: 445
|
Re: Wiring question
you can just either connect the 3 wires to the SAME COLOR wire directly or buy a 3-pin male and female at radio shack.
if that doesn't work ..you might have blown your Hall Effect senser in the SPEED SENSOR..... very easy to rebuild and replace this is a allegro 1302 hall effect sensor www.digikey.com part ----# 620-1012-nd ----$1.55 just hollow out and resolder wires as shown note both types of sensor......... "ROUND" no screw holes and the one pictured below use the same type of hall effect sensor |
|
|
|
 |
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Wiring Question | Electric Club Car | |||
| Wiring Question | Electric EZGO | |||
| Wiring question | Melex | |||
| wiring question | Electric Club Car | |||
| wiring question | Electric Club Car | |||
Linear Mode
