12-24-2011, 07:22 PM | #1 |
Getting Wild
Join Date: Nov 2011
Location: Auburn, AL
Posts: 82
|
Alltrax DCX500IQ
2006 Club Car Precedent 48v electric
Stock Motor Alltrax DCX500IQ COntroller HD 400amp Soleniod 4ga cables I just installed my Alltrax DCX500IQ today. I clocked the cart with my GPS and only got up to 18 MPH. This was with no adjustments. I assumed it would be mor ein the 20-25 MPH. Is this what it was supposed to do? What adjustments do I need to make? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
12-25-2011, 10:02 AM | #2 |
Mr. Helper
Join Date: May 2009
Location: NY Catskills & South carolina
Posts: 445
|
Re: Alltrax DCX500IQ
your mcor is most likely not producting a 100% throttle .
connect your lap top and have someone hold it while you drive. and using alltrex program in "MONITOR TAB" , view the settings to see if the throttle reached 100% . if you don't get 100% load the file i have attached into your controller. It will increase the throttle and give you 100% . i get about 23mph wilth a stock motor on level ground. also here are my settings as a starting point for you . The reason my throttle response says "CUSTOM" is because i use the file that i have attached for you . also note in my signature that i show the same controller as you have . . . |
12-25-2011, 12:30 PM | #3 |
Getting Wild
Join Date: Nov 2011
Location: Auburn, AL
Posts: 82
|
Re: Alltrax DCX500IQ
Mine didn't come with a cable to connect to the computer. What do I need to go buy to connect it?
Merry Christmas! |
12-25-2011, 01:49 PM | #4 |
Gone Wild
Join Date: Nov 2008
Location: Peachtree City, Georgia
Posts: 1,546
|
Re: Alltrax DCX500IQ
The software from Alltrax is Free and is downloaded from their website. As for the cable, you need a USB to RS232 cable or adapter such as these... get one load the drivers for the cable on to your computer. Then have the controller power up and on, then plug the cable in to the controller, then the computer then start the software application.
http://www.ebay.com/itm/USB-RS232-Se...item2a1771f30d http://www.ebay.com/itm/USB-RS232-Se...item2a1448b671 Merry Christmas |
12-25-2011, 06:32 PM | #5 |
Getting Wild
Join Date: Nov 2011
Location: Auburn, AL
Posts: 82
|
Re: Alltrax DCX500IQ
|
12-26-2011, 12:07 AM | #6 |
Mr. Helper
Join Date: May 2009
Location: NY Catskills & South carolina
Posts: 445
|
Re: Alltrax DCX500IQ
get a cable ...........usb to com port (rs232) about 6 feet
the attached file has the program for programming the Alltrex controller and the usb drivers for your laptop don't forget to use the previous file for correcting the 100% throttle issue |
12-26-2011, 11:20 AM | #7 |
Getting Wild
Join Date: Nov 2011
Location: Auburn, AL
Posts: 82
|
Re: Alltrax DCX500IQ
I understand what I need to do it, my question is how does the new file load to the controller? When I have the computer plugged in, controller software open, and open the file does it load automatically?
|
12-26-2011, 02:44 PM | #8 |
Gone Wild
Join Date: Nov 2008
Location: Peachtree City, Georgia
Posts: 1,546
|
Re: Alltrax DCX500IQ
You click on TOOLS and then upgrade and then browse to the file location.
|
12-27-2011, 01:31 AM | #9 | |
Gone Wild
Join Date: Jul 2011
Location: Baton Rouge, LA
Posts: 155
|
Re: Alltrax DCX500IQ
Quote:
I have been having an issue with my throttle only reaching 97-98% much of the time which also does not allow the turbo mode to engage. I am hopeful this is the same issue you describe. Please read below and reply if this file will work with my setup. My setup is mostly the same (DCX500, 400A Solenoid, 4G Wires) on an 07 Precedent except that mine also has a D&D 502:2 motor. When I got the cart it also had the custom curve set. This setting seemed a little touchy (throttle was jerky) so I changed the curve to linear - actually tried several settings but settled on linear. Subsequently, I was not able to reselect the custom curve - If I recall correctly, it shows nothing when I click on it. Can't test this out right now. So anyway, I downloaded the file you posted but will wait to hear if I can use it. |
|
12-27-2011, 08:41 AM | #10 | |
Mr. Helper
Join Date: May 2009
Location: NY Catskills & South carolina
Posts: 445
|
Re: Alltrax DCX500IQ
Quote:
the custom setting ( that is built in ) is not the file that i attached in this thread previous posts.... the new one will correct the 100% issue ( see post #2 for file ) |
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Alltrax,Alltrax,Alltrax | Electric Club Car | |||
Alltrax DCX500IQ and a performance motor | Electric Club Car | |||
500 amp alltrax. which one? | Electric EZGO | |||
Dcx500iq | Electric Club Car | |||
Alltrax 400 amp for PDS | Electric EZGO |