Controller?

rkersh409

I found out that I have a Curtis 1204-015 controller. While looking up new ones I came across a Alltrax NPX4834. First of all will this be a good replacement? All the amperages look the same but it only has 3 large studs on it. B-, B+, and M-. My Curtis has 4 B-, B+, M-, and A2. What and where would A2 go on the Alltrex?

If this will not work in my 1991 Club Car 36V which ones does everyone recommend?

Thanks,
Robert

roady89

A2 is not needed. In stock form a cable runs from the Motor A2 to the controller A2...then another cable from the controller A2 to the F/R switch. When you replace it with another controller or namely one without an A2 terminal you run a cable from the motor A2 straight to the F/R switch connection.

The Alltrax will work fine. An NPX controller I do not think is programable. Be sure and get the right throttle type. An AXE controller would be a better choice.

Golf Cars | Lifted Golf Carts | Electric Golf Carts

Custom EZGO | B&S V-Twin | All Sports Long Travel Lift | 8:1 Gears | 22" Titan AT489's

| | | | | | |