96 48 volt wont move

mikesimz

Hello,
I have a 96 club car 48 volt cart that won't move. The batteries all test out well and are less than a year old. When the key is turned on solonoid clicks and power is to both posts. when I put the rocker switch in reverse it does buzz, the cart just wont move. The computer is 2 months old and i jumped the motor and it did turn (slow but I only had 1 8 volt battery to it. I do not have a wiring diagram and do not now how to test the speed controller.
Any help would be greatly appreciated. Please

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

Stevegrmich

Click here:

96 CC Gas and Electric

shadowman

try jumping the main solenoid see if cart runs.....its the one without resistor coil........follow pos cable from #1 battery and it leads to your main solenoid......make sure you have batteries in and tested load tested as it only takes one to stop cart..............................

mikesimz

I was unable to open the link for some reason, run time error.
I jumped the solonoid (only have one) and it did nothing. All wires coming off the solonoid do have 48 volts, as a matter of fact they have 48 volts when the key is off?
Is there an easy way to test the speed controller?

shadowman

if your cart has a rockerswitch for F&R you should have 2 solenoids.................................