lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car
Electric Club Car Electric DS, and Precedent golf cars



Post New Thread  Reply
Thread Tools Display Modes
Unread 09-17-2012, 06:17 PM   #1
Not Yet Wild
 
NJDevil's Avatar
Club Car
 
Join Date: Jul 2012
Location: NC
Posts: 38
Default mirco switch ?

Ok so I ordered 5 new mirco switch's and this is what was sent Question

the New switch has 2 terminals and old has 1 terminal

Can i use theses if so what terminal do I use?
Attached Images
File Type: jpg 2012-09-17 18.10.34.jpg (351.1 KB, 0 views)
File Type: jpg 2012-09-17 18.03.47.jpg (358.4 KB, 0 views)
NJDevil is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 09-17-2012, 06:46 PM   #2
Getting Wild
 
91kuhndog's Avatar
Club Car
 
Join Date: Sep 2012
Location: Charleston SC
Posts: 122
Default Re: mirco switch ?

If you have a volt meter, check the continuity between the single (power in) and the two side terminals. Set your volt meter to OHMS... it'll buzz at you when you have good continuity but I believe both of the terminals on the side will show cont. when the switch is closed. The sponsors on here sell 2 terminal switches for about $3-4. Hope this helps.

Not to tell you wrong but if you use one terminal, cut the other off with wire cutters.
91kuhndog is offline   Reply With Quote
Unread 09-17-2012, 10:50 PM   #3
nimda
Club Car
 
Join Date: Jun 2007
Posts: 12,913
Default Re: mirco switch ?

That one will work, if it doesn't just switch terminals. One terminal is NC (normally closed ) and the other terminal NO (normally open)....of coarse it could be a double but unlikely. Your original should have on there NC, NO and maybe a C, Com or common. Same with new. Most likely exactly like you had it wired originally.
roady89 is offline   Reply With Quote
Unread 09-18-2012, 09:34 AM   #4
Not Yet Wild
 
NJDevil's Avatar
Club Car
 
Join Date: Jul 2012
Location: NC
Posts: 38
Default Re: mirco switch ?

Quote:
Originally Posted by roady89 View Post
That one will work, if it doesn't just switch terminals. One terminal is NC (normally closed ) and the other terminal NO (normally open)....of coarse it could be a double but unlikely. Your original should have on there NC, NO and maybe a C, Com or common. Same with new. Most likely exactly like you had it wired originally.

Thanks

I did check it with meter got it correct it was the top one that triggers the switch
NJDevil is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
1979 Club Car Electric Mirco switch question Electric Club Car
2009 Precedent run/tow toggle switch replaced with keyed switch Electric Club Car
forward/reverse switch change to toggle switch Electric Club Car
Just got a G9 need to know how to wire ignition switch to push pull switch ASAP! Gas Yamaha
Brown wire from mirco switch where does it go Electric EZGO


All times are GMT -5. The time now is 12:47 PM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.