09-17-2012, 05:17 PM | #1 |
Not Yet Wild
Join Date: Jul 2012
Location: NC
Posts: 38
|
mirco switch ?
Ok so I ordered 5 new mirco switch's and this is what was sent Question
the New switch has 2 terminals and old has 1 terminal Can i use theses if so what terminal do I use? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-17-2012, 05:46 PM | #2 |
Getting Wild
Join Date: Sep 2012
Location: Charleston SC
Posts: 122
|
Re: mirco switch ?
If you have a volt meter, check the continuity between the single (power in) and the two side terminals. Set your volt meter to OHMS... it'll buzz at you when you have good continuity but I believe both of the terminals on the side will show cont. when the switch is closed. The sponsors on here sell 2 terminal switches for about $3-4. Hope this helps.
Not to tell you wrong but if you use one terminal, cut the other off with wire cutters. |
09-17-2012, 09:50 PM | #3 |
nimda
Join Date: Jun 2007
Posts: 13,022
|
Re: mirco switch ?
That one will work, if it doesn't just switch terminals. One terminal is NC (normally closed ) and the other terminal NO (normally open)....of coarse it could be a double but unlikely. Your original should have on there NC, NO and maybe a C, Com or common. Same with new. Most likely exactly like you had it wired originally.
|
09-18-2012, 08:34 AM | #4 | |
Not Yet Wild
Join Date: Jul 2012
Location: NC
Posts: 38
|
Re: mirco switch ?
Quote:
Thanks I did check it with meter got it correct it was the top one that triggers the switch |
|
|
|
Similar Threads | ||||
Thread | Forum | |||
forward/reverse switch change to toggle switch | Electric Club Car | |||
1979 Club Car Electric Mirco switch question | Electric Club Car | |||
2009 Precedent run/tow toggle switch replaced with keyed switch | Electric Club Car | |||
Just got a G9 need to know how to wire ignition switch to push pull switch ASAP! | Gas Yamaha | |||
Brown wire from mirco switch where does it go | Electric EZGO |