New Controller and Motor Wiring 05 cc iq

RESCUEMEDIC13

I just purchased a D&D motor 502.2 and an Alltrax Controller DCX500. The Diagram that i received from Carts unlimited shows B+ on the alltrax controller going to A2 on shunt motor and also M- going to A1 on shunt motor. . The Diagram on D&D website states that B+ on Regen Motor Controller goes to A1 and M- goes to A2. The diagram i am looking at off of D&D website is for an Club car IQ Controller with IQ adapter. I am installing the above listed and dont want to burn wither the controller or the motor i just purchased. Just trying to clarify what is the proper way to connect the wires.



Thank you any assistance you can provide

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

ArmyVetSgtAdkins

Subscribed as I will be doing a motor and controller install myself and want to know correct way of installing..

Golfdog

The diagram you received matches the alltraxinc.com web page "document depo" DCX Controllers. Check it out

scottyb

I answered you in your email. You can wire this either way, I suggest you use the D&D diagram in case the question ever comes up.

RESCUEMEDIC13

Thanks for the help guys

RESCUEMEDIC13

Finishing wiring up the Motor, solenoid, and controller. When placing an in-line fuse, do i put the ann 400 fuse on the between the positive side of the solenoid and the positive battery post or between B- and the negative battery post. I seen wiring diagram for both ways. Does it matter?

scottyb

You can put the fuse on either side of the main supply + or -. I find the corrosion is less further away from the battery vents, I put it on the controller B- lug, between the Lug and the main negative cable.

TahoeDawgZ71