lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car
Electric Club Car Electric DS, and Precedent golf cars



Post New Thread  Reply
Thread Tools Display Modes
Unread 01-21-2013, 07:08 PM   #11
Not Yet Wild
 
Join Date: Jun 2012
Posts: 27
Default Re: Motor won't run

I am lousy with electricity....but I reinstalled my motor in my 96 Club Car
today after replacing the guide ring. On the top of the motor as you face
the motor (standing at the front of the cart at the headlights facing the rear
of the cart, the tailights) there is a left terminal with a green wire and a right
terminal with a orange wire. At the bottom of the motor there is a left terminal with a white wire and a right terminal with a blue wire.
Hope this helps.
tkinche106 is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 01-21-2013, 08:31 PM   #12
haveacupofshutthe****up
 
Stevec3201's Avatar
Club Car
 
Join Date: Jun 2011
Location: Viera, FL
Posts: 739
Default Re: Motor won't run

Quote:
Originally Posted by tkinche106 View Post
I am lousy with electricity....but I reinstalled my motor in my 96 Club Car
today after replacing the guide ring. On the top of the motor as you face
the motor (standing at the front of the cart at the headlights facing the rear
of the cart, the tailights) there is a left terminal with a green wire and a right
terminal with a orange wire. At the bottom of the motor there is a left terminal with a white wire and a right terminal with a blue wire.
Hope this helps.
http://images.search.yahoo.com/searc...lub+car+wiring

Try one of these schematics to check your wiring.
Stevec3201 is offline   Reply With Quote
Unread 02-24-2013, 05:39 PM   #13
Not Yet Wild
 
Join Date: Jan 2013
Posts: 29
Default Re: Motor won't run

Checked wiring diagrams, not sure which one is for the cart, I only have one solenoid the cart has a forward and reverse switch....does that mean there should be two solenoids?..
On the speed controller I was getting 50 volts on both terminals on the back...that should not be right?...I had a yellow wire with power on it but I believe the black is suppose to go to the main battery...so I remover speed controller and had a short from b+ to b- so does this mean bad speed controller???...I also put 50 volts direct to motor and motor turned..any help would be great....getting frustrated....lol. Thanks in advance..
Ultimatepoirier is offline   Reply With Quote
Unread 02-24-2013, 06:36 PM   #14
Gone Wild
 
Join Date: Jul 2012
Posts: 912
Default Re: Motor won't run

It is very possible you fried the controller, they do not like sparks.
Speedchaser is offline   Reply With Quote
Unread 02-24-2013, 07:26 PM   #15
Not Yet Wild
 
Join Date: Jan 2013
Posts: 29
Default Re: Motor won't run

I think u r right, the controller is a ge 220 amp, what should that be replaced with and what's the best place to order one?...thanks
Ultimatepoirier is offline   Reply With Quote
Unread 02-24-2013, 07:31 PM   #16
Not Yet Wild
 
Join Date: Jan 2013
Posts: 29
Default Re: Motor won't run

Also diode has broke off solenoid...I have to replace speed controller but will cart run at all with out that diode? If not does any have any info on that diode?,, thanks again
Ultimatepoirier is offline   Reply With Quote
Unread 02-24-2013, 08:07 PM   #17
Gone Wild
 
Join Date: Jul 2012
Posts: 912
Default Re: Motor won't run

Get a diode for the solenoid, try golf cart king as I think they had a pretty good listing for diodes and resistors.

I would probably just get an upgraded controller at this point, say a 400 amp alltrax AXE, or search for a direct Curtis replacement. At least upgrading will allow a motor upgrade if you decide to in the future.
Speedchaser is offline   Reply With Quote
Unread 02-24-2013, 08:44 PM   #18
Not Yet Wild
 
Join Date: Jan 2013
Posts: 29
Default Re: Motor won't run

What type of diode is it? And will the cart run for testing purposes without it?, the controller u mentioned will fit, it doesn't ave to be exact match correct? As long as it says it will work I guess, thanks
Ultimatepoirier is offline   Reply With Quote
Unread 02-24-2013, 08:51 PM   #19
Not Yet Wild
 
Join Date: Jan 2013
Posts: 29
Default Re: Motor won't run

Also I'm in Canada, it is hard to get some of that stuff shipped here...so I hope if I know what type of diode it is I can buy it locally...thanks
Ultimatepoirier is offline   Reply With Quote
Unread 02-24-2013, 09:28 PM   #20
Gone Wild
 
Join Date: Jul 2012
Posts: 912
Default Re: Motor won't run

Go here, I think you have a 200 amp contactor so probably the 1 amp diode would work. You could also get a controller from these guys as well. They are great to work with and fast turn time. They ship worldwide and can do DHL delivery international 2-3 days.

http://www.evdrives.com/category_s/1834.htm
Speedchaser is offline   Reply With Quote
Reply

Tags
48 volts, motor
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
1978 Harley Motor swap to a CRF 450cc motor. pics inside.. gearing help???/ Gas Harley Davidson
Which gas motor to replace the stock motor in a 1994 Marathon GX444? Gas EZGO
Yamaha G16 Motor Coupling Squealing, Will my old EZGO motor work? Electric Yamaha
Series Motor Versus Regen Motor Electric EZGO
Series Motor Versus Regen Motor Electric EZGO


All times are GMT -5. The time now is 11:57 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.