|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
07-08-2013, 10:51 AM | #1 |
Not Yet Wild
Join Date: Nov 2009
Posts: 15
|
CC trouble no reverse after motor swap
Hi I have a 2007 CC DS, the motor burned up. It still worked but had the tell tale smell and was preforming weak but still had forward and reverse. After a new motor install it operates great but no reverse, the reverse buzzer works and the relay engages but after a second or so the relay turns off even with my foot on the throttle. Any ideas ? I tried resetting the controller (disconnect the batt pack, put in reverse and discharge the controller)
Thank you for any help Todd |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-08-2013, 11:10 AM | #2 |
STEALTH 4X4
Join Date: Sep 2011
Location: GA
Posts: 2,125
|
Re: CC trouble no reverse after motor swap
Is this an IQ cart? What's the serial number?
|
07-08-2013, 11:20 AM | #3 |
Not Yet Wild
Join Date: Nov 2009
Posts: 15
|
Re: CC trouble no reverse after motor swap
I'm not sure what IQ means, it has a shunt motor not series and the serial num isAQ0407-368711
|
07-08-2013, 11:26 AM | #4 |
STEALTH 4X4
Join Date: Sep 2011
Location: GA
Posts: 2,125
|
Re: CC trouble no reverse after motor swap
IQ is the system you have. Its a 2007 CC DS IQ
Check the wiring about 3 more times to make sure everything is where it should be. Did you buy a brand new replacement motor? |
07-08-2013, 11:45 AM | #5 |
Not Yet Wild
Join Date: Nov 2009
Posts: 15
|
Re: CC trouble no reverse after motor swap
Yes it's a new motor and I will check the wiring. Thanks and I'll post an update in a min.
|
07-08-2013, 11:59 AM | #6 |
Not Yet Wild
Join Date: Nov 2009
Posts: 15
|
Re: CC trouble no reverse after motor swap
The wiring checks out, both old and new motors are labeled the same and F1, F2, A1, A2 are landed the same as my diagram. I tried disconnecting the 3 wire telemetry plug on the motor to see if that changed anything but no difference.
|
07-08-2013, 12:06 PM | #7 |
Gone Wild
Join Date: Oct 2008
Location: Ga
Posts: 740
|
Re: CC trouble no reverse after motor swap
WK, just for the hell of it throw your old motor back in and see if reverse still works? If so maybe the new one is bad?
Just a thought, I own 2 ea IQ's and sometimes they won't move at 1st but when the buzzer goes off they always move. Good luck, Steve |
07-08-2013, 12:26 PM | #8 |
Not Yet Wild
Join Date: Nov 2009
Posts: 15
|
Re: CC trouble no reverse after motor swap
When I was originally trying to figure out if it was the motor going bad the last thing I did was put it in reverse while going forward at about 8-10 mph to see if it would regen or go into "creep" mode, it did but then it was done, no fwd or reverse.
|
07-08-2013, 12:30 PM | #9 | |
Gone Wild
Join Date: Aug 2008
Location: Ohio-In Summer, Central Florida-In winter
Posts: 889
|
Re: CC trouble no reverse after motor swap
Quote:
CartTrader |
|
07-08-2013, 12:43 PM | #10 |
Not Yet Wild
Join Date: Nov 2009
Posts: 15
|
Re: CC trouble no reverse after motor swap
That's what I was thinking but wanted other opinions. Thanks though.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
1978 Harley Motor swap to a CRF 450cc motor. pics inside.. gearing help???/ | Gas Harley Davidson | |||
G1 engine swap but now what about reverse? | Gas Yamaha | |||
Reverse alarm stuck - motor won't run forward or reverse | Electric EZGO | |||
G14 having trouble, i just purchased motor. | Electric Yamaha | |||
2003 CC reverse trouble | Electric Club Car |