lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car
Electric Club Car Electric DS, and Precedent golf cars



Post New Thread  Reply
Thread Tools Display Modes
Unread 08-15-2013, 06:14 PM   #1
Not Yet Wild
 
Join Date: Jul 2013
Posts: 7
Default Mounting my 12v converter and fuse panel

93 DS - Ok, just got my 12v converter from ScottyB and my Blue Sea 6 circuit fuse box. Trying to figure out where to mount them. There's room to one side of the F-R switch for both, kinda tight. How hot does this thing get in normal use? There's also a vertical support member on each side just behind the battery compartment with holes already drilled that match the spacing on the converter. I'm concerned about the proximity to the resister, tho. Took the "hood" off to see if there was anywhere in there to mount it, doesn't look promising and I'm concerned about splashing and dirt getting in there.

Any ideas?
AltoonaBound is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 08-19-2013, 02:26 PM   #2
Not Yet Wild
 
Join Date: Jun 2013
Location: Houston, TX
Posts: 39
Default Re: Mounting my 12v converter and fuse panel

Here is how I mounted mine (1990 DS).



I added a piece of 2" aluminum angle as a cross member, and mounted controller, reducer to that and the factory seat support cross member. This results in a very sturdy mounting surface, and is high and dry.

Then, I used the factory heat shield as a convenient place to mount the fuse block. This allows easy access to check fuses or add circuit.
TxAg is offline   Reply With Quote
Unread 08-19-2013, 06:37 PM   #3
Not Yet Wild
 
Join Date: Jul 2013
Posts: 7
Default Re: Mounting my 12v converter and fuse panel

I ended up doing something similar, finished up today. Mounted the converter upside down attached to that same cross-member. Since I still use the resistors, I mounted the fuse-block to one side of the F-R switch on the inside of the body panel.
AltoonaBound is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
G16 Fuse Panel Gas Yamaha
EZGO ~ Mounting Converter Design Center
circuit breakers vs fuse panel Electric EZGO
Fuse panel ? Gas EZGO
Club Car Converter Mounting Suggestions Electric Club Car


All times are GMT -5. The time now is 06:51 PM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.