1986 36v club car won't run after I changed the crows foot plug to Anderson sb50

Ronson

First off I'm a newbie to golf carts, 36 volt electrical, etc, and can really appreciate as basic your suggestions as possible when possible....
My 36volt cart will not move. It did but I had to change a wire and can't recall how to go back. This all started about 3 weeks ago-
I didn't have a battery charger and I bought one on CL but it was wired with a Anderson SB50 plug. What I did was removed the older crows foot plug and aluminum harness including the fuse link and wired the new Anderson plug to the negative on my second to last battery and the positive to a fuse link witha. 30amp fuse directly the what I think is a positive on the FandR switch and i can't recall, since it's been about a month, but I think at one point it moved only when the charger was connected. I swapped the solenoid out even though the old solenoid clicked when accelerator was pressed. I just don't know what to do next. Any suggestions?

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

physcoflip

First use a volt meter and check the pack voltage. You may want to look in the stickies and make sure everything is wired right too.

jjance

This is to late to help you but always draw a diagram before you take anything loose. Or take a picture with your cellphone. Never trust your memory no matter what your age. This comes from a electronics tech with 50 yrs experience.