|10-14-2008, 07:42 PM||#1|
Not Yet Wild
Join Date: Oct 2008
99 controller problem
ok. finally have run this down to the supply voltage out of the controller to the potentiometer. This is the #2 green wire that runs to the micro switch for forward and reverse. the pot checked good so i was told i should have 8 volts output of the yellow wire to the controller but i was only gettin 4 volts and so i ran a test wire from 1 of the 8 volt batteries to the micro switch and it is running fine. but the problem is this bypasses the thermal overload on the controller and also does not cut the voltage to the pot off. so i removed the jumper and now if someone can verify the outputs i mentioned i guess i will be looking for a controller. will someone verify this for me.
the #1 wire supplies the 50 volts from the coil to the controller
the #2 supplies the voltage to the microswitch that supplies the pot
the #3 is the output from the pot to the controller.
is number #2 8 volts and the #3 0 or 1-8 when the pedal is pushed from stop to wide open.????
if this is true does someone have a used curtis 412 48V 300amp or one that would work they would sale or know where to get a good deal on onw.\
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
|Controller upgrade problem||Electric EZGO|
|1997 club car - controller problem?||Electric Club Car|
|Controller?||Electric Club Car|
|controller did not fix problem||Electric EZGO|
|controller||Big Block Talk!|