lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car
Electric Club Car Electric DS, and Precedent golf cars



Post New Thread  Reply
Thread Tools Display Modes
Unread 05-28-2014, 09:20 PM   #31
Gone Wild
 
Blackonblackcc's Avatar
Club Car
 
Join Date: Jan 2011
Location: Illinios
Posts: 411
Default

Already have plans for that money to replace my other cart.

Sent from my SAMSUNG-SM-G900A using Tapatalk
Blackonblackcc is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 05-28-2014, 09:57 PM   #32
Moderator
 
rib33024's Avatar
E-Z-GO
 
Join Date: Apr 2009
Location: FT Lauderdale FL.
Posts: 13,151
Default Re: moving electronics from my 2003 to my 1993

Yes this is true,, there's a post around here that TahoeDawgZ71 posted about taking the rear out and dropping it on the ground


Quote:
Originally Posted by 93yellowclubcar View Post
This works, but it takes a lot of time, and be forewarned that sometimes the armature still won't come off no matter how much you soak, how hard you pry, and invariably you'll damage the armature or mar up the cast rear end housing because you've been using it to pry against. The method to get it off involves taking out the transaxle, having it soaked around the coupler where the motor slides on in PB blaster, and then standing the whole thing up vertically on the passenger side so that the armature faces the ground. Now you can pick it up a couple feet and let it slam down, and just like a giant slide hammer the armature, or whole motor if you've left it intact, will come off. Watch your toes.

Doesn't the swap sound easier?
rib33024 is offline   Reply With Quote
Unread 05-28-2014, 09:59 PM   #33
Gone Wild
 
Blackonblackcc's Avatar
Club Car
 
Join Date: Jan 2011
Location: Illinios
Posts: 411
Default

Quote:
Originally Posted by rib33024 View Post
Yes this is true,, there's a post around here that TahoeDawgZ71 posted about taking the rear out and dropping it on the ground
Can you tag in on here I was looking for stuff on it

Sent from my SAMSUNG-SM-G900A using Tapatalk
Blackonblackcc is offline   Reply With Quote
Unread 05-28-2014, 10:10 PM   #34
Dawg Gone Wild
 
TahoeDawgZ71's Avatar
Club Car
 
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 7,960
Default Re: moving electronics from my 2003 to my 1993

Take the rear end out and drop it on the ground. The motor will come flying off. The part swap should be extremely easy between an 03 and a 99. Everything is the same on the frame. Once you get the body and everything off the cart it's an hour job at the most.
TahoeDawgZ71 is online now   Reply With Quote
Unread 05-28-2014, 10:11 PM   #35
Dawg Gone Wild
 
TahoeDawgZ71's Avatar
Club Car
 
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 7,960
Default Re: moving electronics from my 2003 to my 1993

Here's my post from that thread.......


Take the rear end out of the car. Take the passenger side tire off of the rear end. Take brake drum off. Flip brake drum around backwards and tighten lug nuts to where they are snug enough to hold the drum to the axle. Don't torque them down. With the aid of an assistant, lift the rear end up 3 - 4 feet into the air and drop the rear end onto a concrete floor onto the inverted brake drum. The drum is inverted so you don't damage the wheel studs during this process. The motor will fall off as soon as it hits the ground. If it doesn't, try it again. I've never had to drop one more than three times. Don't laugh. Try it and thank me later.
TahoeDawgZ71 is online now   Reply With Quote
Unread 05-28-2014, 10:55 PM   #36
Gone Wild
 
Blackonblackcc's Avatar
Club Car
 
Join Date: Jan 2011
Location: Illinios
Posts: 411
Default

I will be trying it after the pb blaster fails. Thanks for all the advice. How tricky is it to switch over the mcor and all the hardware connected to it?

Sent from my GT-N8013 using Tapatalk
Blackonblackcc is offline   Reply With Quote
Unread 05-29-2014, 12:10 AM   #37
Moderator
 
rib33024's Avatar
E-Z-GO
 
Join Date: Apr 2009
Location: FT Lauderdale FL.
Posts: 13,151
Default Re: moving electronics from my 2003 to my 1993

here's some info on removing it


Remove all four T40 torx bolts holding floormat down. Remove floormat. Loosen the brake equalizer rod completely. It's left hand threaded at the top FYI. Remove both T30 and both T40 bolts from pedal group and lift it out. Unplug old MCOR. Now you can put it on a bench and swap the MCOR. Re install.
rib33024 is offline   Reply With Quote
Unread 05-29-2014, 12:59 AM   #38
STEALTH 4X4
 
sunoco's Avatar
Club Car
 
Join Date: Sep 2011
Location: GA
Posts: 2,017
Default Re: moving electronics from my 2003 to my 1993

Quote:
Originally Posted by rib33024 View Post
here's some info on removing it


Remove all four T40 torx bolts holding floormat down. Remove floormat. Loosen the brake equalizer rod completely. It's left hand threaded at the top FYI. Remove both T30 and both T40 bolts from pedal group and lift it out. Unplug old MCOR. Now you can put it on a bench and swap the MCOR. Re install.
That procedure is for a Precedent.

You will need to move the pedal assembly components ( accelerator pivot rod, accelerator pivot rod support and white spacer) onto the 93. It's pretty straight forward
sunoco is offline   Reply With Quote
Unread 05-29-2014, 01:30 AM   #39
Moderator
 
rib33024's Avatar
E-Z-GO
 
Join Date: Apr 2009
Location: FT Lauderdale FL.
Posts: 13,151
Default Re: moving electronics from my 2003 to my 1993

Quote:
Originally Posted by sunoco View Post
That procedure is for a Precedent.

You will need to move the pedal assembly components ( accelerator pivot rod, accelerator pivot rod support and white spacer) onto the 93. It's pretty straight forward
Who Precedent Obama

See this is why i should stay out of the CC forum
rib33024 is offline   Reply With Quote
Unread 05-29-2014, 03:02 AM   #40
Dazed & Confused
 
crash test dummy's Avatar
Club Car
 
Join Date: Nov 2011
Location: Z-HELLS FL
Posts: 14,019
Default Re: moving electronics from my 2003 to my 1993

Quote:
Originally Posted by rib33024 View Post
Who Precedent Obama

See this is why i should stay out of the CC forum
ya think ???
crash test dummy is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
2003 club car 48v not moving Electric Club Car
1993 EZ Go not moving Electric EZGO
txt cart electronics Electric EZGO


All times are GMT -5. The time now is 11:01 PM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.