2013 Precedent turn signal wiring problem

spanky32354

I just got this cart and it already has a plug and play headlight/taillight/brake light installed. I don't believe it's a Club Car brand kit because the brake activator is located behind the brake pedal pad and there is no timer or brake bracket/spring installed. My questions are: is the kit a 48 volt kit (I can't find a voltage reducer). I just installed a 48-12 volt reducer for the turn signal kit but am having problems. I need to hook up the t/s switch wire to the brake light switch. How do I know which wire that is since is has no brake bracket? By tapping into the headlights/brake light wires am I plugging into 48 volts? Any help will be truly appreciated.

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

mrgolf

You likely already had a factory voltage reducer, or if you have 12 volt batteries they ran off one of your batteries = 12 volt.
Photo of the battery area would help.

spanky32354

6 8volt batteries

miker

did you look up front underneath that's where a plug and play reducer goes and the horn and directional wires are there,the brake wires are under the floor

spanky32354

Thanks miker, I'll check that out for the reducer. I've found the wires for the brake light under the floor but not sure which one to use since it doesn't have the spring switch.

spanky32354

Here's the wiring diagram.

Attached Files

Scan_Doc0003.pdf (597.3 KB, 0 views)

miker

did you take off the dash cover , look to see how many harnesses go to the front, on the brakes there should be bullet plugs,