|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
12-01-2014, 03:59 PM | #1 |
Not Yet Wild
Join Date: Dec 2014
Posts: 4
|
no reverse on txt
I have a 2002 ezgo txt everything was working fine but rf swithed got really hot decided to change it out got new upgraded rf switch changed it out verifying all wiring now cart solenoid clicks and moves forward but no click are move in reverse but if I jump solenoid in reverse cart will move in reverse any suggestions?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
12-01-2014, 04:25 PM | #2 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,344
|
Re: no reverse on txt
You may have a small wire(s) connected wrong on the micro switch
|
12-01-2014, 04:50 PM | #3 |
Not Yet Wild
Join Date: Dec 2014
Posts: 4
|
Re: no reverse on txt
I switched the lil blue and orange wire not have reverse no forward
I checked ohms as in diagram the forward has 0.7 ohms and the reverse has 0.4 ohms |
12-01-2014, 04:53 PM | #4 |
Not Yet Wild
Join Date: Dec 2014
Posts: 4
|
Re: no reverse on txt
First picture was of old fr switch this is new fr switch
|
12-02-2014, 10:28 AM | #5 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: no reverse on txt
Sounds like the cam is not rotating all the way into the Reverse position.
The roller on the lever arm of MS-2 (Microswitch with Red and Blue wires on it) has to drop in an indentation on the circumference of the cam in both the F and R positions of the cam, to complete the solenoid activation circuit. (All the other microswitch does is sound the beeper and tell the controller to go into 1/2 speed mode) The mounting holes for the f/R assembly are oblong for a reason. |
12-02-2014, 12:03 PM | #6 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,344
|
Re: no reverse on txt
Test and be sure the F&R switch center rotating cam is rotating until it hits the stops in both F and R positions. If you are unsure if it going to the stops, remove the linkage and rotate the center pivot shaft with a 9/16ths wrench on the cart's front side of the switch.
For this reason we suggest you mark the location of the old switch on the floor before removing it. |
12-02-2014, 06:50 PM | #7 |
Not Yet Wild
Join Date: Dec 2014
Posts: 4
|
Re: no reverse on txt
Thanks guys sure enough got home removed linkage and it was off just a hair adjusted fr switch works great. And you know I had marked the old switch BUT there was some rust accumulated so I buffed area and repainted and lost the marks but all is good now really appreciate the help
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
wiring a reverse light to the reverse buzzer? | Gas Yamaha | |||
Goes in reverse when switch is in forward. does nothing with swicth in reverse | Electric EZGO | |||
Reverse won't go but if I pump gas it slams into reverse | Electric Club Car | |||
Foward in reverse and reverse in forward | Electric Club Car | |||
Reverse alarm stuck - motor won't run forward or reverse | Electric EZGO |