lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric EZGO
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV.



Post New Thread  Reply
Thread Tools Display Modes
Unread 11-11-2008, 04:58 PM   #1
Not Yet Wild
 
Join Date: Nov 2008
Posts: 4
Cool What motor can I use?

I have a 1986 ezgo and I`m rebuilding it.I would like to find a replacement motor.As I was looking at them I didn`t see the same motor I need.The one in it is a 5BO48JB783A EZGO Textron,2HP,36Volt.The cart #`s are S/N392023,M/C C1586 .I`f someone could help me I would appreciate it.
robnwendy is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 11-11-2008, 06:51 PM   #2
WILD
 
caddymankc's Avatar
E-Z-GO
 
Join Date: May 2007
Location: lebanon county,pa
Posts: 1,266
Default Re: What motor can I use?

Is it a pds or series?
caddymankc is offline   Reply With Quote
Unread 11-11-2008, 07:04 PM   #3
The Last Moja Morani
 
shadowman's Avatar
Club Car
 
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
Default Re: What motor can I use?

they more than likely don,t make that motor anymore so hang onto it in case you need to have it rebuilt, i,ll look to see if i can find any that they are using to replace it.........................................
shadowman is offline   Reply With Quote
Unread 11-11-2008, 07:08 PM   #4
Not Yet Wild
 
Join Date: Nov 2008
Posts: 4
Default Re: What motor can I use?

kinda figured that but thought I could upgrade without changing controlers ,also battries are in series
robnwendy is offline   Reply With Quote
Unread 11-11-2008, 07:11 PM   #5
The Last Moja Morani
 
shadowman's Avatar
Club Car
 
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
Default Re: What motor can I use?

well if its an 86 it won,t have a controller.........................
shadowman is offline   Reply With Quote
Unread 11-11-2008, 07:17 PM   #6
Not Yet Wild
 
Join Date: Nov 2008
Posts: 4
Default Re: What motor can I use?

has the coil speed control? with the wiper setup,didn`t they have that tell early 90`s
robnwendy is offline   Reply With Quote
Unread 11-11-2008, 07:44 PM   #7
The Last Moja Morani
 
shadowman's Avatar
Club Car
 
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
Default Re: What motor can I use?

thats a resisto cart.......where are they located in canter of battery bank or off belind left rear inner fender area?............... regardless we,ll find eiyther a motor or we,ll be able to have yours redone but they do make aftermarket motors i beleive.....................
shadowman is offline   Reply With Quote
Unread 11-11-2008, 07:48 PM   #8
The Last Moja Morani
 
shadowman's Avatar
Club Car
 
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
Default Re: What motor can I use?

if the motor can,t be replaced and i think with some looking around it will be able to they do make all the parts to repair it.............what exactly is the problem your hasving with your motor?...........................
shadowman is offline   Reply With Quote
Unread 11-11-2008, 07:53 PM   #9
steeplejack x
 
pggroves's Avatar
E-Z-GO
 
Join Date: Jan 2007
Location: Republic of Texas
Posts: 3,337
Default Re: What motor can I use?

If your motor is parallel with the rear axle then it likely has a helical cut gear on the end of the shaft that mates with the differential. It is not splined as are the newer motors. Your best bet is to send the motor to EMP for a rebuild. They do good work and are a sponsor of this fine forum.

My $.02. Spend as you wish!
pggroves is offline   Reply With Quote
Unread 11-12-2008, 07:54 AM   #10
Not Yet Wild
 
AimlessRolling's Avatar
E-Z-GO
 
Join Date: Oct 2008
Location: Clear Lake Shores, Texas
Posts: 26
Default Re: What motor can I use?

Quote:
Originally Posted by pggroves View Post
If your motor is parallel with the rear axle then it likely has a helical cut gear on the end of the shaft that mates with the differential. It is not splined as are the newer motors. Your best bet is to send the motor to EMP for a rebuild. They do good work and are a sponsor of this fine forum.

My $.02. Spend as you wish!
http://www.empinc.biz/

I second that. I had called three or four places and could not get what I was looking for before I called EMP. I placed the order with EMP on the first call there. Very knowledgable, reasonable prices, give them a call and see if they can help you.

Aimless
AimlessRolling is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric EZGO


Thread Tools
Display Modes


Similar Threads
Thread Forum
Replacing original motor with a GE motor??? Electric Club Car


All times are GMT -5. The time now is 10:22 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.