|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
07-08-2015, 09:35 PM | #1 |
Not Yet Wild
Join Date: May 2015
Posts: 8
|
Bent Tie Rod on Steering Box Assembly
I was doing some off-roading in my 2013 EZGO TXT 48v earlier with some friends. Everything was okay until I hit a concrete block about 1 foot tall that was dug into the ground. It only hit my front right (passenger) tire and I was going about 14 mph. After I flew out, I got back in. I hit the gas and I thought everything was okay until I tried to turn left. It stops about 1 inch from being straight so it slowly goes right. I can turn all the way right but it stops just before half way (going straight). I got home after 20 minutes of struggling (normal 5) and jacked the cart up. It was clear the the tie rod (upper) was bent at a 90 degree angle (look at the picture). How do I take it off and bend it back straight, if possible. Please help.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-08-2015, 10:28 PM | #2 |
Guest
Posts: n/a
|
Re: Bent Tie Rod on Steering Box Assembly
you can buy a replacement tie rod and end ... i would not try to fix that one
|
Tags |
bent, rod, tie |
|
|
Similar Threads | ||||
Thread | Forum | |||
Bent movable contact shaft and arm assembly | Electric EZGO | |||
Bent Steering Column - 93' Marathon | Gas EZGO | |||
bent steering-arm? | Electric Club Car | |||
WTB: Steering box assembly | Golf Carts and Parts | |||
steering box Assembly | Golf Carts and Parts |