|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
08-29-2015, 06:11 PM | #1 |
Getting Wild
Join Date: Aug 2015
Location: Louisiana
Posts: 118
|
Is my motor shot ??
I have a question for you guys .. I pulled the motor from my 92 ezgo electric. "2hp" three wheel. I automatically suspected all the electrical components are bad because that is how my luck goes. So I wanted to start with the motor. "All batteries were fried." I tried the a1 to s1 and a2 to s2 and then hook pos and neg to each. Motor didn't make a sound. What could this mean besides the motor is shot. I would like to just change the brushes and not do a complete motor and controller overhaul. Any thoughts ? Thanks ! Please Let me know if you need more info ....
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-29-2015, 07:36 PM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Is my motor shot ??
That is the test for a "sepex" motor, you have a "series" motor. Test is different. Also, test must be done with motor on axle if the drive end does not also have a bearing to support it. You need to link one "S" terminal to one "A" terminal (its not picky which A & S terminal you use), then apply at least 12v to the terminals that have nothing hooked to them.
|
08-29-2015, 07:54 PM | #3 |
Getting Wild
Join Date: Aug 2015
Location: Louisiana
Posts: 118
|
Re: Is my motor shot ??
I did this as well. Is this right for my motor ? http:/ /youtu be/nXM3oIJ EnWk .. The forum won't let me post a link since I have not been a member long enough. But if you take the spaces out it should take you to the link. I am very green to this golf cart thing .. Please excuse my ignorance.
|
08-29-2015, 08:31 PM | #4 |
Guest
Posts: n/a
|
Re: Is my motor shot ??
92 ezgo is "series" motor
motor test WARNING you don't want to make a big spark anywhere near the battery. jumper cables may be used black clip on battery negative, red clip on motor A1 post, tap the other ends together |
08-29-2015, 09:39 PM | #5 |
Getting Wild
Join Date: Aug 2015
Location: Louisiana
Posts: 118
|
Re: Is my motor shot ??
Wonderful ... I'll follow the directions. Keep your fingers crossed for me !!
|
08-30-2015, 10:32 AM | #6 |
Getting Wild
Join Date: Aug 2015
Location: Louisiana
Posts: 118
|
Re: Is my motor shot ??
One other thing ... The little round yellow resister that was tied in above the controller had broken off. Does this piece need to be there in order for the whole system to function ? Since all of the batteries were bad in the cart, I Hooked up two deep cycle marine batteries in order to put out 24 volts to the system. I didn't get a sound when I pushed the go petal .. Neither in forward or reverse. Would 24 volts be enough for the system temp. Run ? My main objective is to try out all electrical components to make sure of how much I am going to be spending before I order the 500 dollars worth of batteries for a cart that does not run ...
|
08-30-2015, 11:11 AM | #7 |
Guest
Posts: n/a
|
Re: Is my motor shot ??
resister needs to be there to work , 24v not enough to trigger 36v solenoid
|
08-30-2015, 12:05 PM | #8 |
Getting Wild
Join Date: Aug 2015
Location: Louisiana
Posts: 118
|
Re: Is my motor shot ??
Ahh.... Makes sense. I'll solder it in place and grab another battery and see what happens.
|
08-30-2015, 12:11 PM | #9 | |
Guest
Posts: n/a
|
Re: Is my motor shot ??
if motor is still out just do the motor test
here is solenoid test solenoid test Quote:
|
|
08-30-2015, 12:12 PM | #10 |
Getting Wild
Join Date: Aug 2015
Location: Louisiana
Posts: 118
|
Re: Is my motor shot ??
Got cha !
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Controller is shot | Electric EZGO | |||
My motor is shot.... what next... | Electric EZGO | |||
I think my controller is shot | Electric EZGO | |||
will 36v cc motor take a 48v "shot" occasionally | Electric golf carts |