|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
04-15-2016, 07:01 PM | #1 |
Not Yet Wild
Join Date: Jul 2014
Posts: 11
|
36 volt pds low power 2-4 code
I'm helping a friend with his cart. It has good batteries and good charge. Diagnostic mode beeps 2-4. Cart works but moves slow 4mph ish. All cables, terminals have been cleaned and are tight. If tow/run is in run position, key on, forward/reverse in neutral position solenoid will click as soon as switch is moved to forward or reverse (without touching pedal). Any ideas?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-15-2016, 07:50 PM | #2 |
Getting Wild
Join Date: Feb 2016
Location: Bluffton, SC
Posts: 122
|
Re: 36 volt pds low power 2-4 code
Might be a bad speed sensor
|
04-15-2016, 09:51 PM | #3 |
Not Yet Wild
Join Date: Jul 2014
Posts: 11
|
Re: 36 volt pds low power 2-4 code
I will check the speed sensor according to other posts tomorrow. But that wouldn't cause the solenoid to engage when forward reverse switch is moved, would it?
|
04-16-2016, 06:22 AM | #4 | |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: 36 volt pds low power 2-4 code
Quote:
2-4 code is solenoid coil failure. Since your cart is moving the coil must not be failed but the solenoid may be welded. Remove the precharge resistor (if it has one) and verify the solenoid main contact is making and breaking the connection between the 2 large posts. |
|
04-16-2016, 07:27 AM | #5 |
Not Yet Wild
Join Date: Jul 2014
Posts: 11
|
Re: 36 volt pds low power 2-4 code
Roll away alarm works as it should. Removed speed sensor and magnet was secure to its base. Screw was a little loose so I tightened it and replaced sensor. Same symptoms. What next?
|
04-16-2016, 07:31 AM | #6 |
Not Yet Wild
Join Date: Jul 2014
Posts: 11
|
Re: 36 volt pds low power 2-4 code
This solenoid does not disengage moments late. With no power applied there is no continuity between the big lugs on the solenoid.
|
04-16-2016, 07:51 AM | #7 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: 36 volt pds low power 2-4 code
Solenoid should not latch with the key or F&R so you have some type of controller failure and the 2-4 code is a signal something is wrong with the solenoid activation circuit.
|
Tags |
pds 2-4 code, slow cart |
|
|
Similar Threads | ||||
Thread | Forum | |||
1998 48 Volt Club Car Warning Light Code | Electric Club Car | |||
36 Volt DS no power | Electric Club Car | |||
36 Volt DS no power | Electric Club Car | |||
12 volt power | Electric Club Car | |||
36 Volt EZ-Go, boost of power, put a 12-Volt car battery in it? | Electric EZGO |