|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
08-17-2016, 11:49 AM | #1 |
Getting Wild
Join Date: Jan 2011
Location: Dayton Ohio
Posts: 130
|
93 Marathon GE motor Vibration
This motor has been rebuilt (Before I got it) I know that a kid rode it in a plat that had long steep hills. I put in new batteries and test rode it . Bad vibration in motor. Worse at just below full speed.Bad enough to make the bag well roar! Took motor apart and rear bearing and brushes all fairly new. But spin the armature and the wiring on the end of armature is way off center . Commutator at brushes runs true. Shafts run true. Could this be from overspeed coming off steep hills too fast .Kids DO Like to go FAST !!!
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-17-2016, 08:18 PM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: 93 Marathon GE motor Vibration
could be, but that kind of damage usually results in a Very short life after the fault occurs. often all over in a matter of seconds. are you describing uneveness in the commutator (copper bars where the brushes deliver power to the armature)?
|
08-17-2016, 09:54 PM | #3 |
Getting Wild
Join Date: Jan 2011
Location: Dayton Ohio
Posts: 130
|
Re: 93 Marathon GE motor Vibration
No that surface where the brushes ride on is running true the other end where the copper comes out turns and goes back to the other end those are not even and looks like they have been slung or bent off to one side and higher on one side than the other as you spin it and watch them . The shaft is turning true where the spines are. I did notice that 1 wire is has sort of a grey look to it all the rest look like varnished copper or normal. Like maybe a short on that one . But it ran fine as far as power goes. Didn`t run it much as vibration was unacceptable. Nothing was hot or even warm after 10 min. of riding . Then in the shop it went for motor removal
|
08-17-2016, 10:47 PM | #4 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: 93 Marathon GE motor Vibration
one grey wire huh? it needs a rebuild before it kills your controller.
|
08-18-2016, 05:20 AM | #5 |
Getting Wild
Join Date: Jan 2011
Location: Dayton Ohio
Posts: 130
|
Re: 93 Marathon GE motor Vibration
Yep, It got a used motor from the shelf. Ok now.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Marathon vibration and noise | Gas EZGO | |||
94 Marathon Oil Leak/Vibration | Gas EZGO | |||
1980 Marathon Vibration Help | Gas EZGO | |||
1986 Marathon vibration | Gas EZGO | |||
Ezgo marathon motor vibration | Gas EZGO |