lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric EZGO
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV.



Post New Thread  Reply
Thread Tools Display Modes
Unread 10-12-2016, 01:19 AM   #1
Not Yet Wild
 
Join Date: Oct 2016
Posts: 4
Default Rxv will not move, beep, or unlock brake.

2009 rxv cart. Turn key and nothing happens. I have change key switch, it has 48 volts on blue wire coming from charging port, has new motor brake. selonoid not pulling in ( will pull in if I jump a ground from battery bank to - side of selonoid. Cart will not move in tow either. Brake will unlock if I follow instruction under the controller cover and my be the plugs around.
Acman4545 is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 10-12-2016, 03:33 AM   #2
Getting Wild
 
sltintexas's Avatar
E-Z-GO
 
Join Date: Apr 2016
Location: North Texas
Posts: 142
Default Re: Rxv will not move, beep, or unlock brake.

Have you measured the voltage of the battery pack? I had similar experience when mine sat and batteries drained. RXV will shutdown once batteries get to a certain point.
sltintexas is offline   Reply With Quote
Unread 10-12-2016, 11:48 AM   #3
Not Yet Wild
 
Join Date: Oct 2016
Posts: 4
Default Re: Rxv will not move, beep, or unlock brake.

Yes I have load tested the batteries also, voltage at battery pack is 53.8. All terminals are clean. The cart was running fine and just quit and will not do anything.
Acman4545 is offline   Reply With Quote
Unread 10-12-2016, 06:23 PM   #4
Getting Wild
 
hmsnider's Avatar
E-Z-GO
 
Join Date: Oct 2007
Location: Charleston, SC
Posts: 106
Default Re: Rxv will not move, beep, or unlock brake.

Its a long shot but there is a connector under the cup holder that must be plugged in. If it has worker loose cart wont move. Just a thought. Good luck and let us know what you find.
hmsnider is offline   Reply With Quote
Unread 10-12-2016, 08:26 PM   #5
Not Yet Wild
 
Join Date: Oct 2016
Posts: 4
Default Re: Rxv will not move, beep, or unlock brake.

Yes sir, I check that also, made sure on the back side of the plug with an ohm meter.
Acman4545 is offline   Reply With Quote
Unread 10-12-2016, 11:17 PM   #6
Over This Interview Is...
 
cgtech's Avatar
Yamaha
 
Join Date: Jun 2012
Location: AZ
Posts: 11,952
Default Re: Rxv will not move, beep, or unlock brake.

Search the site for Rxv Danaher troubleshooting Guide. It has many tests & specs for you to test. Sounds like possible "DC bus low" from failed Resistor control module. Usually that failure will still allow brake unlock, but I have seen that code/failure do many strange things. Don't spend another dollar on parts until you get the guide & start checking every spec in there. (also, stop "jumping" the solenoid, you could kill your controller by jumping circuits that are managed by the controller). The Rxv has sensitive electronics, it ain't like an old "resistor car" that barely cares what you do to it.
cgtech is offline   Reply With Quote
Unread 10-17-2016, 09:58 PM   #7
Not Yet Wild
 
Join Date: Oct 2016
Posts: 4
Default Re: Rxv will not move, beep, or unlock brake.

I was able to get a controller from a working cart, I now can hear the solenoid pull in, the cart will check the motor brake, the buzzer sounds, but still will not move. The closest cart shop that has a programmer is about 160 miles away...I have check both brake and throttle switches per the specs on the troubleshooting guide. The brake will now unlock in tow mode. Anything else I should check?
Acman4545 is offline   Reply With Quote
Unread 10-18-2016, 01:29 AM   #8
Over This Interview Is...
 
cgtech's Avatar
Yamaha
 
Join Date: Jun 2012
Location: AZ
Posts: 11,952
Default Re: Rxv will not move, beep, or unlock brake.

There's about 50 tests you could try in the guide. It's a "shotgun approach" without the codes given by the programmer.
cgtech is offline   Reply With Quote
Unread 10-18-2016, 08:15 AM   #9
Gone Insane
E-Z-GO
 
Join Date: Oct 2015
Location: TN/NC/GA Tri-state area
Posts: 2,459
Default Re: Rxv will not move, beep, or unlock brake.

Quote:
Originally Posted by Acman4545 View Post
I was able to get a controller from a working cart, I now can hear the solenoid pull in, the cart will check the motor brake, the buzzer sounds, but still will not move. The closest cart shop that has a programmer is about 160 miles away...I have check both brake and throttle switches per the specs on the troubleshooting guide. The brake will now unlock in tow mode. Anything else I should check?
Where are you located? I know you have a 2009, but I have some spare parts with me that are universal for all RXVs. I even have complete Curtis wiring harnesses and controllers that can be used to diagnose issues with the RXV chassis components.

Bob
BobBoyce is online now   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric EZGO


Thread Tools
Display Modes


Similar Threads
Thread Forum
Reverse Beep Always present- Cart will not move F or R Electric EZGO
2010 ezgo rxv no click from solenoid no reverse beep doesn't move Electric EZGO
36V EZ-GO - Cart won't move, but will beep when in Rev Electric EZGO
Reverse beep-beep-beep delete? Electric EZGO
Unlock Club car 1989 Gas EZGO


All times are GMT -5. The time now is 08:46 PM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.