|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
11-17-2016, 01:38 PM | #1 |
Not Yet Wild
Join Date: Jan 2015
Location: Arizona
Posts: 18
|
RXV Intermediate Gear Bearing replacement
Anyone out there with an EZGO RXV (2010) that has replaced the intermediate gear bearings on the transaxle (Dana)? Going to be replacing the input shaft/bearings on mine and thought about replacing these bearings. According to the service manual, it sounds to easy! It says "Push intermediate gear assembly (1) toward narrow side of gear housing and install bearing (3) on intermediate gear assembly shaft. Don't they mean "press" as in some type of special tool to press the gear assembly into the bearing while inside the case?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
11-17-2016, 03:08 PM | #2 |
Gone Wild
Join Date: Aug 2014
Location: Duncan Corners
Posts: 905
|
Re: RXV Intermediate Gear Bearing replacement
No they mean buy a new gear assy with bearings already installed then replace assy.
That IS relitively easy. they never consider YOU pressing bearings off and on. |
11-17-2016, 03:45 PM | #3 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: RXV Intermediate Gear Bearing replacement
They don't even press on, the bearings just slide off after snap ring is removed. Intermediate shaft cannot be removed with bearings in place. You need the plugs that cover the bearings also to do this job. This job should be considered a "pull the entire axle and do it on the bench" type of job. Because the carrier & ring gear has to be removed to allow the intermediate shaft to move.
|
11-17-2016, 11:27 PM | #4 |
Not Yet Wild
Join Date: Jan 2015
Location: Arizona
Posts: 18
|
Re: RXV Intermediate Gear Bearing replacement
Is it common for these bearings to wear out?
|
11-18-2016, 06:49 AM | #5 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: RXV Intermediate Gear Bearing replacement
Input shaft inner bearing, yes. Intermediate shaft bearings, not really.
|
11-18-2016, 09:15 AM | #6 |
Gone Wild
Join Date: Aug 2014
Location: Duncan Corners
Posts: 905
|
Re: RXV Intermediate Gear Bearing replacement
Sorry i was thinking input shaft..... My bad.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
WTB Yamaha rear end intermediate gear | Golf Carts and Parts | |||
G1 crankshaft bearing replacement | Gas Yamaha | |||
Intermediate Bearing Replacment | Electric EZGO | |||
99 ds motor bearing replacement | Electric Club Car | |||
Bearing replacement | Electric EZGO |