|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
11-27-2016, 04:25 PM
|
#1 |
|
Not Yet Wild
Join Date: May 2016
Posts: 3
|
1998 EZ-GO will not run unless I run a jumper wire from controller m- to motor A1
Hello, I have been trying to figure this 1998 ez-go cart for years. I have replaced the batteries, cables, solenoid. solenoid clicks but cart does not move.
After four hours of troubleshooting today I found that if I run a car jumper cable from controller M- to the motor A1 it seems to run great. I clean all of the wire connections to make sure I was getting a good ground, but still nothing. Any help would be greatly appreciated. Thanks |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| solenoid jumper wire guage | Electric EZGO | |||
| EZGO runs if jumper wire from solenoid to battery | Electric EZGO | |||
| Jumper wire from solenoid? | Electric Club Car | |||
| 2009 g29 jumper wire????? | Gas Yamaha | |||
| Does my Solenoid need a jumper wire? | Electric EZGO | |||
Linear Mode
