Lost Reverse when replacing cables.

craigy

Last night, I replaced the last two cables to the controller. The short one from the soilenoid to the controller, and the lowest one on the F&R switch. After I tightened them up, and connected the ground, I did not have reverse. Forward works fine, soilenoid clicks when the shifter is in reverse, but no movement. I have printed a wiring diagram to try and figure out what happened. As far as I can remember, I put everything back in the right place, but between my three year old daughter and two phone calls.........I may have been distracted

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

craigy

Found it! I had a friend over to make sure all wiring was correct. After that was verified, we could not figure out why reverse was not working. While still looking thru diagrams, my friend pushed the throttle down (with key on) and wiggled reverse lever. No it was not on jack stands. I did move several feet prior to him letting go. Looks like I had misaligned one of the studs on the FNR switch while replacing cables. Now have 48 volts, and reverse. The LED light on the alltrax does not stay on. If I remember right, it is supposed to be on when the key is on. Can anyone verify this?

www3rd

the way my cart is wired and i think it is right the key just gives potential the micro sw in the foot ped makes the loop the put control power to col and contholler small red wire to sol and jumps to controller