|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
02-11-2017, 04:28 PM | #1 |
Not Yet Wild
Join Date: Feb 2017
Location: Longview, TX
Posts: 13
|
Question about controller mounting
In a 2004 ezgo txt, does an alltrax controller mount on the existing heat sink?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-11-2017, 04:35 PM | #2 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,344
|
Re: Question about controller mounting
Yes it can mount on the existing heat sink with four 1/4-20x 1.5 inch bolts
|
02-11-2017, 05:32 PM | #3 |
Not Yet Wild
Join Date: Feb 2017
Location: Longview, TX
Posts: 13
|
Re: Question about controller mounting
Thanks. I bought a used cart recently. I'm in the process of going through everything to determine what is good and what needs replacing. The factory heat sink is broken at the bottom, close to where the tabs bolt to the frame. Therefore, the controller is just laying in the housing loosely. I think I'm going to need an upgraded controller to handle the hills where I plan to ride, but wanted to make sure an upgraded controller would still use a stock heat sink before I ordered a new one.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Controller Over-Motor Mounting Bracket | Electric EZGO | |||
Controller mounting | Lifted Golf Carts | |||
Mounting upgraded controller | Electric EZGO | |||
Mounting a SPM controller to a 92 DS | Electric Club Car | |||
Alltrax controller mounting | Electric Club Car |