02 ezgo 36v electric txt wiring diagram?

Golfer24/7

Can someone provide me with a wiring diagram for my 02' ezgo 36v electric txt (non-dcs) i believe. the f/r switch is on the dash and tow/run switch is on the box where solenoid is located inside. I'm new to owning a golf cart and am ready to start fixing it up, just need to make sure i get all the wiring down before i make any big mistakes. Thanks in advance!

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

LVCJ

Try this one:

http://www.buggiesgonewild.com/elect...-diagrams.html

scottyb

Use the flow chart here > http://www.cartsunlimited.net/tech-help-.html
It sounds like you have a PDS drive cart.

rib33024

If you have a Tow/Run switch. Flip it to TOW before you do anything to the wiring

Golfer24/7

Thanks for the links guys. I believe it is a pds cart based on the flow chart and f/r tow switch. This forum seems really helpful. I'm sure this won't be my last question. Thanks again!

Golfer24/7

I believe this diagram is the one for my cart ( hope i attached it right ). The only thing is and again please excuse my ignorance when it comes to working on carts and trying to figure out how to read a diagram but in this diagram is it showing the key switch to be inside the box with run tow switch or just infront of the box mounted to cart frame? or could the key switch be behind the dashboard? i will snap a few pics when i get home tonight to help better illustrate what i am talking about. Also one more thing the cart runs forward and reverse fine but has no beep when in reverse. not sure if the previous owner disabled this feature or if it is broke. any ideas will be greatly appreciated and please bare with me on all of my "newbie" type questions because i know ive got a lot of them!

Thanks



ezgo txt pds drive diagram.jpg

scottyb

The diagram just shows wire paths and not the true location of any of it's components. The key switch is in the dash, right above your rabbit's foot.
And the beeper is located behind the keyswitch plate. They are often disconnected but, if you need one I have many

Golfer24/7

Thanks scottyb you and everyone else on these forums have already been a big help! Any ideas or recommendations on how to get back there without having to pull dash out and drill rivets?? there is an opening to the left of the f/r switch i can stick my hand in but not much else.

orangeman6

I'm not sure exactly what all you're going to need to do behind your dash but you can pop the cup holders out to get some room to reach up in there. If you do need to remove the switch plate, it's not a big deal to drill out and replace the rivets. HF has rivet guns for cheap that will do the job.

yurtle

I have a '98 series txt, so it may be different, but I can remove the EZGO logo on front and access the back of the dash. It ain't easy, but depending on what you need to do, it may be easier than removing the beer holder.