|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
06-30-2017, 11:37 AM | #1 |
Not Yet Wild
Join Date: Jan 2017
Posts: 19
|
36V EZGO no go
I parked my 36Volt EZGO in the garage in mid April, went to use it the other day and it will not go, batteries are charged and show proper voltage. The solenoid clicks in forward or reverse, but the buggy will not move Any ideas or help would be much appreciated.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-30-2017, 12:08 PM | #2 |
Gone Wild
Join Date: Jun 2017
Location: NC
Posts: 368
|
Re: 36V EZGO no go
|
06-30-2017, 04:15 PM | #3 |
Not Yet Wild
Join Date: Jan 2017
Posts: 19
|
Re: 36V EZGO no go
36 volt ezgo with a Altrax AXE controller
|
06-30-2017, 04:23 PM | #4 |
Not Yet Wild
Join Date: Nov 2016
Location: West Columbia, SC
Posts: 51
|
Re: 36V EZGO no go
VH, have you tried following the trouble shooting steps outlined in the sticky, ezgo troubleshooting. You need a DVM, some time and a LOT of patience. The trouble shooting guide will provide you with a step by step guide to help you pin point your problem.
|
07-01-2017, 07:25 AM | #5 |
Not Yet Wild
Join Date: Jan 2017
Posts: 19
|
Re: 36V EZGO no go
Thanks BMR4106, where can I find that procedure. Is it online somewhere??
|
07-01-2017, 07:37 AM | #6 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: 36V EZGO no go
The AXE control fits a Series drive cart. The control has a LED status light which will show power on or flash trouble codes. What does the AXE LED do when you try to go? And does the solenoid click when you try to go?
Below is the solenoid activation circuit for series TXT. There should be 36v at both ends of every red line (wire) when you press the go pedal. Start at the source end (receptacle or battery) and see where the power stops. |
07-01-2017, 07:39 AM | #7 |
Not Yet Wild
Join Date: May 2017
Location: The Island
Posts: 42
|
Re: 36V EZGO no go
http://www.buggiesgonewild.com/elect...agnostics.html
I am interested to see what your problem might be, the above was not helpful to me. |
07-01-2017, 09:01 AM | #8 |
Master of All Things
Join Date: May 2013
Location: West Columbia, Texas
Posts: 17,998
|
Re: 36V EZGO no go
and before you do ANYTHING.....Just a word of warning.....jack up your cart and place it on jackstands.......fore if you don't, and find the problem or it fixes itself when a lose wire becomes "not lose" ,....and you step on the "Gas" and either yourself of someone else gets run over, or you run into something.
|
07-01-2017, 09:03 AM | #9 |
Not Yet Wild
Join Date: Jan 2017
Posts: 19
|
Re: 36V EZGO no go
Scotty, The solenoid clicks in forward and reverse, the controller green light blinks 4 times then stays on solid. Any help appreciated!!
|
07-01-2017, 09:23 AM | #10 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: 36V EZGO no go
The controller says everything is a go. One last LED test = at full throttle the LED should turn orange. if yes look to the high amp cables or F&R switch for the trouble.
|