|
| |||||||
| BGW Gear | Register | Golf Cart Pics | Site Sponsors | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
| | Thread Tools | Search this Thread | Display Modes |
03-07-2009, 11:16 AM
| #1 |
| Not Yet Wild  Join Date: Feb 2009 Location: Gilbert, SC
Posts: 17
|  axe 4844 / initial programming? Just installed the controller and the cart will barely move... does it need initial programming? I was hoping for a plug -n- play and fine tune it later... Is it not initially programmed to atleast a baseline?  Just spoke to Carl at EV drives and he is saying its something with the ITS.... solid red LED when the accelerator is pushed after a few seconds of green.... I gotta check voltage between pins 2 and 3... |
|  |
 Today
| |
| Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum | |
|
03-10-2009, 07:43 AM
| #2 |
| Not Yet Wild Join Date: Feb 2009 Location: Gilbert, SC
Posts: 17
| Re: axe 4844 / initial programming? just an update..... Carl at EV drives says it has to be shipped back to him because it's stuck in some kind of "boot" mode...  |
|
| |
|
05-09-2009, 04:46 PM
| #3 |
| Administrator  Join Date: Jun 2007
Posts: 8,762
| Re: axe 4844 / initial programming? I have never heard of "boot" mode. Alltrax controllers come shipped ready to run. Tweak afterward. (That is if you buy one ready to go. If you buy used you may have to swap setings around.) |
| | |
| |
|
05-09-2009, 05:41 PM
| #4 |
| Carts Unlimited  Join Date: Dec 2007 Location: So Cal
Posts: 25,367
| Re: axe 4844 / initial programming? ......if green when at rest and then solid red when you push the gas then it is in the wrong throttle input mode for your cart .... |
|
| |
|
05-09-2009, 05:58 PM
| #5 |
| Not Yet Wild Join Date: Feb 2009 Location: Gilbert, SC
Posts: 17
| Re: axe 4844 / initial programming? this was an old thread of mine.... all with that is working fine now... it was the low voltage setting... my new problem is with the solenoid.... it happened today.... it's a new post from today... tks |
|
| |
|
| ||||||
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Forum | |||
| yamaha g8 alltrax 4844 | Electric Yamaha | |||
| 
| 
| 
| 
| 
Linear Mode
