Wiring diagram for series cart w/for-rev contactors and upgrades

Goliath

I looked at the stickied wiring diagrams, but don't see one applicable.

I'm converting a '92 Marathon to lithium, and upgrading motor, controller etc, including the SW202 forward/reverse contactors.

Does anyone have a clear wiring diagram that shows all the components? I'm trying to figure out where to put everything in the battery compartment, and would like to see how it all gets connected.

I'm installing an Alltrax SR, and downloaded the install manual. It has one page for "Generic Series w/Reverse", see attachment below.

https://drive.google.com/open?id=1MD...k_6tFeDmInC9R8

Is this correct, or is there a better one available someone can recommend?

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

Sideways

I just did the SR controller and SW182 reversing contactor (smaller version of the 202)

http://www.buggiesgonewild.com/elect...r-project.html

Goliath

Thanks, but I think your setup is slightly different.

orangeman6

Goliath, did you get your stuff from Scotty? He sends diagrams with it that I found a lot easier to follow than the stuff that came from Alltrax. There’s a couple different ways that it can be done, which threw me for a loop for a bit. However, again, if you just follow Scotty’s stuff you’ll be fine.

Apologies if I’m way off on what you’re asking.

Goliath

So, that's kind of a sore point.

I've been communicating with Scotty. I had every intention of ordering the controller, solenoid, cables, contactors, etc from him.

I asked him, a few days ago, if he could send me a more clear diagram. The reason is, I need to figure out where everything will be placed, so I know how long some of the cables need to be before I order them. I stated that in the email to him.

He basically said he would send clearer diagrams AFTER I placed the order. I found that annoying, as I need the diagram before I place the order, so I can determine cable length, which is why I'm asking here.

I'm sure if I email golfcarcatalog, or another supplier, they would send one, but I thought I'd give site sponsors the first shot at my $.

kgsc

Try this one.
https://i1.wp.com/i205.photobucket.c...size=593%2C520

scottyb

Making a custom cable set before the components are in hand or mounted may be asking for errors.
The diagram posted on my website does show the routes of all of the high amperage cables.
I strongly suggest you get the components mounted and diagrams in hand before you proceed no matter where you buy.

Goliath

@kgsc - Thanks, that's simple and clear.
@scotty - Thanks for the suggestion. I think mounting all the crap up before ordering cables is actually a much better approach. BTW, the pic on your website is of such low res, blowing it up helps little.

handtools

I don't know if this will help or not but it's all I got!

.02 EZ TXT revised 7_14_14 reversing contactor wiring.jpg

Sideways