|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
08-13-2018, 08:46 PM | #1 |
Not Yet Wild
Join Date: Jul 2018
Location: Ontario, Canada
Posts: 16
|
1995 36v nor working ... No solenoid click
Hey there I have a 1995 ezgo that will not work ... I have 36 volts on the two small terminals of the solenoid and the positive side of the solenoid ... And nothing on negative side .... When I jump the negative battery terminal to the blue wire .. The solenoid engages ... I have replaced controller and solenoid ... It's is a dcs cart and I have noticed the resistor gets very hot when hooked up .... No diode .... Any help would be appreciated
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-13-2018, 08:56 PM | #2 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,406
|
Re: 1995 36v nor working ... No solenoid click
Welcome to BGW
The negative side of the solenoid activation circuit is supplied by the controller at pin 7. See diagram. Remove this wire from the solenoid and put a jumper wire from the Battery B- to this small solenoid post. If the cart then runs, the controllers are bad. |
08-13-2018, 09:07 PM | #3 |
Not Yet Wild
Join Date: Jul 2018
Location: Ontario, Canada
Posts: 16
|
Re: 1995 36v nor working ... No solenoid click
I have replaced controller ... Thinking that was the issue ... I have noticed that if I wiggle the 10 pin connector the first wire arcs on controller ... Red and yellow ... Could this be a bad wire somewhere?
|
08-13-2018, 09:40 PM | #4 |
Not Yet Wild
Join Date: Jul 2018
Location: Ontario, Canada
Posts: 16
|
Re: 1995 36v nor working ... No solenoid click
Also when I do jump the solenoid the cart still doesn't move ... Sometimes it will go forward but not reverse ... I can hear the motor trying
|
08-14-2018, 08:48 PM | #5 |
Not Yet Wild
Join Date: Jul 2018
Location: Ontario, Canada
Posts: 16
|
Re: 1995 36v nor working ... No solenoid click
Is there a way I can test motor? Could motor wreak controller even after a new one is installed? I installed a refurbished Curtis controller and solenoid still did not engage
|
|
|
Similar Threads | ||||
Thread | Forum | |||
G19e Stooped working, no click, intermittent buzzer | Electric Yamaha | |||
1995 EZGO click but wont move | Electric EZGO | |||
txt no solenoid click and battery meter on dash quit working | Electric EZGO | |||
1995 48v DS no solenoid click & no movement intermittently | Electric Club Car | |||
1995 regen no click | Electric Club Car |