|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
08-07-2019, 10:24 AM
|
#1 |
|
3 Linked
Join Date: Apr 2011
Location: Columbia, Sc
Posts: 488
|
New to me cart,
So I just picked up a 2013 ezgo 48volt from my sister, and as i was replacing a wire on the batter one of the ended of another wire came right off ( a lot of corrosion ), well this cable goes to the charger, but i am not sure if i can just put a new end on it because of this gray box on the end of it, which i would have to cut off to put a new end on. my question is, can i just remove it and add the end and be good, or do i need to replacing it.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
08-07-2019, 11:10 AM
|
#2 |
|
Techno-Nerd
 Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: New to me cart, need help
The gray cable senses battery temperature. If the corrosion on the ring terminal didn't wipe out the sensor, just duct-tape it to one of the batteries.
|
|
|
|
|
08-07-2019, 12:19 PM
|
#3 |
|
Getting Wild
Join Date: Jan 2019
Posts: 81
|
Re: New to me cart, need help
If I remember correctly there is two wires inside the sleeve. Ezgo does not sell the temp sensor separately. It's part of that harness. And yes it's about $140
Sent from my SM-G960U using Tapatalk |
|
|
|
|
08-07-2019, 12:32 PM
|
#4 |
|
3 Linked
Join Date: Apr 2011
Location: Columbia, Sc
Posts: 488
|
Re: New to me cart, need help
ok, so i can just tape it to a batters, so i can still charge them then and everything will work.
|
|
|
|
|
08-07-2019, 12:49 PM
|
#5 | |
|
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: New to me cart, need help
Quote:
|
|
|
|
|
|
08-07-2019, 01:05 PM
|
#6 | |
|
3 Linked
Join Date: Apr 2011
Location: Columbia, Sc
Posts: 488
|
Re: New to me cart, need help
Quote:
Thanks  |
|
|
|
|
|
08-07-2019, 01:08 PM
|
#7 |
|
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,140
|
Re: New to me cart, need help
Try the function of the charger first and if it works run with it. If not that sensor can be replaced or bypassed.
|
|
|
|
|
08-07-2019, 04:15 PM
|
#8 |
|
3 Linked
Join Date: Apr 2011
Location: Columbia, Sc
Posts: 488
|
Re: New to me cart, need help
This is what the charger is showing, and on the cart, where the charger plugs into, there is a green light that is blinking.
|
|
|
|
|
08-07-2019, 05:44 PM
|
#9 |
|
Getting Wild
Join Date: Jan 2019
Posts: 81
|
Re: New to me cart, need help
Looks like its charging. If you have volt meter check battery back should be something around 52 volts while charger charging... good luck
Sent from my SM-G960U using Tapatalk |
|
|
|
|
08-07-2019, 05:52 PM
|
#10 | |
|
3 Linked
Join Date: Apr 2011
Location: Columbia, Sc
Posts: 488
|
Re: New to me cart, need help
Quote:
|
|
|
|
|
Linear Mode
