|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
08-31-2019, 11:17 AM | #1 |
Not Yet Wild
Join Date: Apr 2017
Location: Baileyton, TN
Posts: 22
|
Help EZGO TXT PDS died
My 2007 EZGO just died last night. I use it for work around the campground, I drove it up to the office, got off went in the office for 2 minutes to check something came back out got on and nothing. Checked the reed switch someone had already bypassed that on mine. I ran a jumper wire from the battery + side of the battery pack to the other side of the solenoid, to bypass the ignition switch and solenoid and still nothing. Any ideas?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-31-2019, 12:00 PM | #2 |
......................
Join Date: Apr 2009
Location: FT Lauderdale FL.
Posts: 16,416
|
Re: Help EZGO TXT PDS died
Rear Wheels off the ground. Check to see if you have pos and neg on the small posts on the solenoid. see which one is missing. + or -
|
08-31-2019, 12:48 PM | #3 |
Not Yet Wild
Join Date: Apr 2017
Location: Baileyton, TN
Posts: 22
|
Re: Help EZGO TXT PDS died
What do you mean? I found a wiring diagram yellow wire on the small post of selonid is positive and the Blue wire is negative. How do you check to see if one + or - is missing?
|
08-31-2019, 03:41 PM | #4 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Help EZGO TXT PDS died
The PDS controller supplies both B+ (yellow wire) and B- (blue wire) to the solenoid coil.
You have to have Run/Tow in Run, Keyswitch On and F/R in either F or R to get B+ to solenoid coil. Then when you push the pedal, the pedal switch supplies battery pack voltage to J4 Pin-1 telling the controller to connect B- to the blue wire, energizing the solenoid. ------------ When you said you ran a jumper from + side of the battery pack to the other side of the solenoid, are you referring to the solenoid's large terminals? If so, verify you have battery pack voltage (38.2V when fully charged) on all the pins highlighted in red on the attached schematic. Also attached is a picture of a PDS controller with Pin-1 highlighted on all of the jacks. |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
EZGO - 2007 PDS - Just died... | Electric EZGO | |||
2003 ezgo died | Electric EZGO | |||
Electric ezgo died. Sugguestions please | Electric EZGO | |||
EZGo Died on the way home. | Electric EZGO | |||
82 ezgo that died | Electric EZGO |