lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric EZGO
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV.



Post New Thread  Reply
Thread Tools Display Modes
Unread 10-21-2019, 06:40 PM   #1
Not Yet Wild
 
Join Date: Oct 2019
Posts: 34
Default 2 wire ignition switch question

Rewiring my new used 93 ezgo txt 36v series cart. The person who had it before me had wires all over. Some hooked up, some loose about the cart, so I'm redoing everything, neat and clean.

There are green and blue wires that come out of the dash. The green splits between the battery meter and one of the two ignition connections. The blue wire is not hooked up to anything.

The other switch connector (2 of 2) is an aftermarket red wire that goes directly to battery positive.


Question is where does the blue wire connect to?

Thanks
Chris
Chris379 is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 10-21-2019, 06:44 PM   #2
Not Yet Wild
 
Join Date: Oct 2019
Posts: 34
Default Re: 2 wire ignition switch question

Forgot to upload pic
Chris379 is offline   Reply With Quote
Unread 10-21-2019, 06:46 PM   #3
Not Yet Wild
 
Join Date: Oct 2019
Posts: 34
Default Re: 2 wire ignition switch question

Try again
Attached Images
File Type: jpg 20191021_174637.jpg (233.5 KB, 0 views)
Chris379 is offline   Reply With Quote
Unread 10-21-2019, 07:28 PM   #4
Gone Wild
 
Timberwolflt's Avatar
E-Z-GO
 
Join Date: Sep 2017
Location: South Texas
Posts: 260
Default Re: 2 wire ignition switch question

Share a picture of your controller so that they can know what drive system your cart has
Timberwolflt is offline   Reply With Quote
Unread 10-21-2019, 07:42 PM   #5
Gone Wild
 
Timberwolflt's Avatar
E-Z-GO
 
Join Date: Sep 2017
Location: South Texas
Posts: 260
Default Re: 2 wire ignition switch question

I was thinking the blue and green went to the ign switch but it seems every system was different
Timberwolflt is offline   Reply With Quote
Unread 10-21-2019, 08:01 PM   #6
Gone Insane
 
Mooncarter's Avatar
Club Car
 
Join Date: Oct 2016
Location: Richmond, VA
Posts: 8,312
Default Re: 2 wire ignition switch question

Quote:
Originally Posted by Timberwolflt View Post
I was thinking the blue and green went to the ign switch but it seems every system was different
Looks to me as if somebody has butchered the wiring using mostly red.

Should be simple enough though. Pack voltage to key switch. Then switched side going to FNR for the activation circuit and one splitting off to the meter.
Mooncarter is online now   Reply With Quote
Unread 10-21-2019, 08:02 PM   #7
Techno-Nerd
 
JohnnieB's Avatar
E-Z-GO
 
Join Date: Jun 2011
Location: West Virginia
Posts: 15,945
Default Re: 2 wire ignition switch question

Blue wires are for factory lights, but not sure if you have the key switch with lights terminals.
Attached Images
File Type: jpg Keyswitch wiring Series.JPG (92.1 KB, 0 views)
JohnnieB is offline   Reply With Quote
Unread 10-21-2019, 08:09 PM   #8
Gone Wild
 
Timberwolflt's Avatar
E-Z-GO
 
Join Date: Sep 2017
Location: South Texas
Posts: 260
Default Re: 2 wire ignition switch question

I think I’d start by tracing the other end of that wire loom and find out exactly what those two wires were connected to... assumptions can cause expensive problems when the wiring has been so extensively ‘modified’ as it clearly has been there
Timberwolflt is offline   Reply With Quote
Unread 10-21-2019, 08:28 PM   #9
Gone Wild
 
LukeL's Avatar
Yamaha
 
Join Date: Jun 2017
Location: Savannah, GA
Posts: 4,390
Default Re: 2 wire ignition switch question

A ‘93 TXT shouldn’t exist. What’s the MFG code?
LukeL is offline   Reply With Quote
Unread 10-21-2019, 08:31 PM   #10
Gone Insane
 
Mooncarter's Avatar
Club Car
 
Join Date: Oct 2016
Location: Richmond, VA
Posts: 8,312
Default Re: 2 wire ignition switch question

Quote:
Originally Posted by LukeL View Post
A ‘93 TXT shouldn’t exist. What’s the MFG code?
I was wondering the same thing when I was looking for diagrams.
Mooncarter is online now   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric EZGO


Thread Tools
Display Modes


Similar Threads
Thread Forum
EZGO Ignition Switch Help (where to connect hot wire on Radio to Ignition Switch) Gas EZGO
ignition switch wire diagram Gas Club Car
New ignition switch - 3 wire to 4 prong ???? Electric EZGO
How do you wire a key switch ignition ? Gas Club Car
Just got a G9 need to know how to wire ignition switch to push pull switch ASAP! Gas Yamaha


All times are GMT -5. The time now is 03:34 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.