Help Clearify wiring.
Good morning all. Thank you for your help ahead of time. Could someone help out and tell me if Im on the right track with this cart? Working on an EZGo Shuttle serial number 2567921 with the Curtis 1268-5411 24 pin controller. The controller is not powered on, cart is unresponsive, no solenoid click, there is no status light blink, and the reverse buzzer does not sound when the direction switch is in reverse. Batteries are good and hold a charge. Current battery voltage is 49.7. I have tested all switches for continuity and all work properly except the ITS because I don't have any voltage out of the controller to test it. I have battery voltage coming from the reed switch, I have battery voltage on both sides going in and out of the run/tow switch. I don't not have any voltage to the key switch or the directional switch. If Im reading the wire chart attached I should have battery voltage at the directional switch, the key switch and the pedal micro switch. If this is correct it looks like the voltage should come from the b+ of the pack, and not from the controller, and travel to these switches which in turn travel to the controller from the switches. Im thinking the wire harness has a cut wire or two going to the front of the cart. Can I run B+ power to the key switch and directional switch for testing purposes and see how the controller responds with out frying the controller?
|