lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric EZGO
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV.



Post New Thread  Reply
Thread Tools Display Modes
Unread 07-08-2009, 01:31 PM   #1
Not Yet Wild
E-Z-GO
 
Join Date: Jun 2009
Location: Jax., Fl.
Posts: 3
Default Micro switch on fwd and rev switch has bee removed

The micro switch above item 38 on the attachment file drawing has been removed has been removed on this ezgo 1986 marathon cart. This cart was submerged in water for a short period of time, but during this time two of the complete micro switch wires were melted off. All switches test good I can jumper the solenoid and make it drive in forward but not in reverse. There is no back up buzzer on it.

Can any body recommend how to rewire with out the 2nd micro switch or should I reconnect as per this drawing. Is this the correct drawing for a ezgo 1986 Marathon textron model F0586.

Is the solenoid on the back side of the accelerator switch 36 volts? Is the key switch 12 or 36 volts.

Regards,

Ruworkin
Attached Images
File Type: jpg ezgosolidstatecm8.jpg (9.0 KB, 121 views)
ruworkin is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 07-08-2009, 07:34 PM   #2
Gone Crazy
 
Fleck's Avatar
E-Z-GO
 
Join Date: Nov 2008
Location: Pine Hill NJ
Posts: 560
Default Re: Micro switch on fwd and rev switch has bee removed

Quote:
Originally Posted by ruworkin View Post
The micro switch above item 38 on the attachment file drawing has been removed has been removed on this ezgo 1986 marathon cart. This cart was submerged in water for a short period of time, but during this time two of the complete micro switch wires were melted off. All switches test good I can jumper the solenoid and make it drive in forward but not in reverse. There is no back up buzzer on it.

Can any body recommend how to rewire with out the 2nd micro switch or should I reconnect as per this drawing. Is this the correct drawing for a ezgo 1986 Marathon textron model F0586.

Is the solenoid on the back side of the accelerator switch 36 volts? Is the key switch 12 or 36 volts.

Regards,

Ruworkin
I'm not a sparky expert but I would replace the second micro switch. I tryed to enlarge the image you posted but couldn't. From what I can see it looks like you have a diagram for a controller cart and not a resistor cart. Check the stickys at the top of the page and there is probably the correct one there.
Fleck is offline   Reply With Quote
Unread 07-08-2009, 08:19 PM   #3
Gone Wild
E-Z-GO
 
Join Date: Nov 2008
Location: MI, West Coast
Posts: 235
Default Re: Micro switch on fwd and rev switch has bee removed

Quote:
Originally Posted by ruworkin View Post
The micro switch above item 38 on the attachment file drawing has been removed has been removed on this ezgo 1986 marathon cart. This cart was submerged in water for a short period of time, but during this time two of the complete micro switch wires were melted off. All switches test good I can jumper the solenoid and make it drive in forward but not in reverse. There is no back up buzzer on it.

Can any body recommend how to rewire with out the 2nd micro switch or should I reconnect as per this drawing. Is this the correct drawing for a ezgo 1986 Marathon textron model F0586.

Is the solenoid on the back side of the accelerator switch 36 volts? Is the key switch 12 or 36 volts.

Regards,

Ruworkin
No this is not the right diagram for your cart unless it has been modified to controller. IMHO the reverse buzzer is critical. I would not run a cart without this safety feature. Accidents happen in a blink of the eye. If you or someone jumps into the cart expecting to go forward and instead backs up and runs into, over, through....It could be a bad day. That said get the proper micro switch, if it is the reverse micro switch it depends on if your cart is a resistor, or a controller which one you need. Please install a buzzer.
iaefebs is offline   Reply With Quote
Unread 07-08-2009, 09:09 PM   #4
steeplejack x
 
pggroves's Avatar
E-Z-GO
 
Join Date: Jan 2007
Location: Republic of Texas
Posts: 3,341
Default Re: Micro switch on fwd and rev switch has bee removed



pggroves is offline   Reply With Quote
Unread 07-08-2009, 10:23 PM   #5
Gone Crazy
 
Fleck's Avatar
E-Z-GO
 
Join Date: Nov 2008
Location: Pine Hill NJ
Posts: 560
Default Re: Micro switch on fwd and rev switch has bee removed

See; I told you one of the smart guys would show up
Fleck is offline   Reply With Quote
Unread 07-09-2009, 07:27 AM   #6
Not Yet Wild
E-Z-GO
 
Join Date: Jun 2009
Location: Jax., Fl.
Posts: 3
Default Re: Micro switch on fwd and rev switch has bee removed

Greetings all,

I did not notice until last night that I had installed the wrong jpeg file and immediately all responses identified this issue and gave me valuable input and finally the drawing that matches what I have.

What a totally awesome Forum.
http://www.buggiesgonewild.com/image...s/thumbsup.gif
Thanks to All,

Ruworkin
ruworkin is offline   Reply With Quote
Reply

Tags
1986, electric, ezgo, marathon, txt
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric EZGO


Thread Tools
Display Modes


Similar Threads
Thread Forum
Micro Switch or Solenoid Electric Club Car
solenoid? micro switch? fuse? Electric EZGO
1988 ezgo micro switch Electric EZGO
Can The Micro Switch Short Out? Gas Yamaha
micro switch Electric EZGO


All times are GMT -5. The time now is 10:10 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.