lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric EZGO
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV.

Post New Thread  Reply
Thread Tools Display Modes
Unread 01-31-2008, 12:37 AM   #1
Gone Wild
buckmanmike's Avatar
Join Date: Oct 2007
Location: Snellville, Ga.
Posts: 1,071
Default 82 resistor to controller

I had to post here also. I finally got my cart running yesterday. I did a motor test and had no problems there. I rewired motor afterwards and everything is working fine. I must have had a wire wrong or a bad connection. I can only tell a great improvement in the smoothnest of acelleration, Batteries were not fully charged. I'll be back in home in a couple of weeks, hope to raise to 60v or 72v then.
I have installed a czonka relay, good to 96 volts, a 750amp 48-72 volt controller, and a pb-6 pot box. Gone are the old resistors and speed board. I am running on 48v now, but need new batteries which I was waiting to do after I got cart running again. Time for some voltssssssssssss.
buckmanmike is offline   Reply With Quote
Alt Today

Golf car forum Sponsored Links

This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric EZGO

Thread Tools
Display Modes

Similar Threads
Thread Forum
resistor cart Electric Club Car
Resistor to controller Extreme DC!
Convert Resistor to Controller? Electric EZGO
need help with Melex resistor Melex
Red Hot Resistor Coil Electric EZGO

All times are GMT -5. The time now is 11:31 PM.

Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.