Curtis PMC Connector PN#s needed

69makinitmine

I've got an OEM Curtis PMC I'm retrofitting to my old Cushman. I'm building the wiring harness but can't find the nylon connectors anywhere. This controller has the freedom chip in it so there are 5 total connectors. They will all be male connector with female pins. There is a rectangular 10 pin, a square 4 pin, a flat 4pin, and a flat 3 pin. Does anyone know type name or part numbers for these? I should be able to get them through Mouser with ID help... Thanks all!

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

rabbitreborn

not trying to rain on your parade, but you did get the motor that goes with that right? That controller is for a Sepex system and will not work on a series cart.

and if you did get the motor that came with it, the speed sensor in the motor will eliminate your need for the flat 3 pin plug.

The Flat 4 pin plug is for the "personality" chips and the chips cost $5-$10 each. Again, not something you need to purchase an aftermarket plug for.....

69makinitmine

A friend of mine has the rear axle with sepex motor on it, givin it to me. Also have the "Chip" for the flat four. The chip is nothing more than a connector with jumper wires, a 4 "din" switch could have been used but then they couldn't charge 10 bucks for a .50 cent connector...