|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
08-04-2010, 12:54 AM | #1 |
Not Yet Wild
Join Date: Aug 2010
Posts: 2
|
96 TXT shudders - won't go
Have a 96 TXT that slowly had troubles holding a charge. Believe it is DCS (controler has Run - Tow/Maintenance switch. Changed batteries. F/R buzzer works but when I depress pedal the cart shudders a bit but won't go forward. Checked all battery connections. Please help
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-04-2010, 01:57 AM | #2 |
Not Yet Wild
Join Date: Aug 2010
Location: South Afrika
Posts: 12
|
Re: 96 TXT shudders - won't go
Check the brushes in the motor, or cables running from the motor to the controller needs replacement.
|
08-04-2010, 05:58 AM | #3 |
Gone Wild
Join Date: Jun 2010
Location: Central Florida
Posts: 2,757
|
Re: 96 TXT shudders - won't go
Age of batteries? Voltage of pack? Voltage under load?
|
08-04-2010, 09:57 PM | #4 |
Not Yet Wild
Join Date: Aug 2010
Posts: 2
|
Re: 96 TXT shudders - won't go
Batteries are brand new. I ran the troubleshooting check found posted here. Voltage at the battery posts is 38.3. It is the same at the battery side of the solenoid. Was unsure of what wires 1, 2, 3 & 4 to the controller are for the continuity check so I went to the next step. The voltage on the controller side of the solenoid dropped 11 volts to 27.1. According to that post that means my resistor is bad? Would that it behave this way?
|
08-04-2010, 10:07 PM | #5 |
Just one day at a time
Join Date: Sep 2009
Location: South TX
Posts: 8,650
|
Re: 96 TXT shudders - won't go
If you have a DCS cart and you had too low of a voltage you could of damaged the controller. DCS carts are very picky about this, is the cart have any mods?
|
08-04-2010, 10:10 PM | #6 |
Gone Wild
Join Date: Jun 2010
Location: Central Florida
Posts: 2,757
|
Re: 96 TXT shudders - won't go
#1 is power
#2 and #3 are the throttle input #4 is half speed reverse what are you getting for voltage on each side of the solenoid with the pedal down? |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
36V EZ GO Shudders and Won't Go (Sometimes) | Electric EZGO | |||
Cart "Shudders in Forward Gear" | Electric Club Car |