|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
07-11-2011, 04:04 PM | #1 |
New Cart Security System
Join Date: Dec 2010
Location: Gonzales, LA
Posts: 463
|
Load testing with no hills...
I need to test two batteries in my pack that ran down realllly low - as I live in South Louisiana, well, there aren't any hills.
Suggestions on how to accomplish a load test? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-12-2011, 08:37 AM | #2 |
New Cart Security System
Join Date: Dec 2010
Location: Gonzales, LA
Posts: 463
|
Re: Load testing with no hills...
Anyone? It took 27 hours but the charger finally kicked off for these two batteries and said they were charged. After sitting overnight, pack voltage is at 51.7. But would like to load test them so I don't get left in the woods...
|
07-12-2011, 11:01 PM | #3 |
New Cart Security System
Join Date: Dec 2010
Location: Gonzales, LA
Posts: 463
|
Re: Load testing with no hills...
okay - one more try. Batteries sat for about 12 hours. Pack voltage at 51.6. Pulled out into the street floored it and my meter dropped to 44 for a 1/4 second, then back up to 47.1 up to 48, depending on the slight grade. Drove it for about 3 miles around the neighborhood, lots of slowdowns for the turns and full power out of the curves and turns. Ending voltage 50.2.
Can anyone explain what the numbers above are telling me if anything? Thanks... |
07-12-2011, 11:19 PM | #4 |
Gone Wild
Join Date: Mar 2009
Location: Roseville, CA
Posts: 2,757
|
Re: Load testing with no hills...
Your batteries sound like they are fine.
Pack voltage of 51.6 is just over 100%. A drop of less than 15% under full throttle is OK as well (yours is 14%). I don't think you need to load test these batteries, just keep them charged. |
07-12-2011, 11:26 PM | #5 |
New Cart Security System
Join Date: Dec 2010
Location: Gonzales, LA
Posts: 463
|
Re: Load testing with no hills...
Thanks!
|
07-12-2011, 11:31 PM | #6 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,418
|
Re: Load testing with no hills...
Get a voltage reducer to avoid this situation in the future
|
07-13-2011, 02:10 AM | #7 |
New Cart Security System
Join Date: Dec 2010
Location: Gonzales, LA
Posts: 463
|
Re: Load testing with no hills...
That wasn't the issue - my deep cycle marine charger only had a few strands of copper holding the alligator clip on. Charged and when I went to take it off o go riding the clips were too hit to touch and that clip actually broke off the cable. Pack voltage seemed fine so we went riding and made it a long way but ended up c r a w l i n g back to camp with literally no juice left. 6 batteries, the ones charged through the delta Q read a little over 6 volts each - these two read about 3v each. Still not 100% sure I didn't fry them.
|
07-13-2011, 08:59 AM | #8 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,418
|
Re: Load testing with no hills...
It is hard on a battery to be drawn down to 3v. Some permenant damage has been done. You will just have to figure out how much by monitoring the pack. this becomes harder to do with two separate chargers. Try to get the 2 'packs' equal and then check them closely after draw down (use).
The best thing you can do here is get a 48v charger for the whole pack and spread those 2 out in the pack. That is just opinion. |
07-13-2011, 09:11 AM | #9 |
New Cart Security System
Join Date: Dec 2010
Location: Gonzales, LA
Posts: 463
|
Re: Load testing with no hills...
Trying to get the charger - need to sell my delta q off first I guess.
Let's say these two batteries are 7 and 8 in my pack. Right now batteries 1-6 are charged from the Delta Q - and 7 and 8 from the 12v charger. If I swapped these into the bagwell, so they charge off of the Delta Q with batteries 1-4, would that be better until I know if they are shot? It's a long walk back to the camp if I get stranded... |
07-13-2011, 10:38 AM | #10 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,418
|
Re: Load testing with no hills...
You should be able to access their health with a hydrometer and a voltmeter. I would force charge them fairly high right now and let them settle for about 18 even 24 hours and check voltage and specific gravity..... then write down the standing voltage of every battery in the pack to the 100th of a volt (6.37) and run the cart for 30 min. to an hour, and immediately recheck the voltages on all the batteries. Compare the second readings to the first readings and you will have an pretty good answer to your question
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Low speed/under load cut out | Electric Club Car | |||
how to load test battery if no load tester | Electric Club Car | |||
How to check for voltage, Load or no load? | Electric EZGO | |||
Rebuild....needs to climb hills...LOTS OF HILLS! | Electric Club Car | |||
Load Testing | Electric Club Car |