|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
12-30-2011, 02:32 PM | #1 |
Not Yet Wild
Join Date: Jun 2009
Location: Grand Isle Louisiana
Posts: 30
|
New motor and cart wont go
Just put a new d&d motor on my pds ezgo and it wont go more than 5 feet.My voltage reading on my battery pack is 38.2 and under load it goes down to 37 i checked each battery and they all stay above 6 volts,what can i try next.I also have a alltrax 500 amp controller.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
12-30-2011, 03:20 PM | #2 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: New motor and cart wont go
Okay which D&D motor and which Alltrax and what solenoid are you using?
|
12-30-2011, 03:59 PM | #3 |
Not Yet Wild
Join Date: Jun 2009
Location: Grand Isle Louisiana
Posts: 30
|
Re: New motor and cart wont go
|
12-30-2011, 05:18 PM | #4 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: New motor and cart wont go
200 or 400 amp solenoid?
|
12-30-2011, 05:19 PM | #5 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: New motor and cart wont go
How is the controller programmed?
Sorry for all the questions. |
12-30-2011, 05:34 PM | #6 |
Not Yet Wild
Join Date: Jun 2009
Location: Grand Isle Louisiana
Posts: 30
|
Re: New motor and cart wont go
Thanks for the help, here is the programming and 200 amp solenoid
field map4 max output 100% under voltage 38 over voltage 60 throttle up 4 throttle down 8 brake current 65% top speed 100 Throttle response EZ go its custom |
12-30-2011, 07:27 PM | #7 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: New motor and cart wont go
Sorry I'm in and out but mostly out today and tonight..... everything looks correct. Battery cables all good and connections clean & tight?
Try another throttle profile... Run it in diagnostic mode if you have a laptop or test the ITS output if not... |
12-31-2011, 08:51 AM | #8 |
Not Yet Wild
Join Date: Jun 2009
Location: Grand Isle Louisiana
Posts: 30
|
Re: New motor and cart wont go
How do i run it in diagnostic mode i do have a laptop and how do i test the ITS output thanks again for all the help.
|
01-01-2012, 04:00 PM | #9 |
Not Yet Wild
Join Date: Jun 2009
Location: Grand Isle Louisiana
Posts: 30
|
Re: New motor and cart wont go
|
01-01-2012, 09:09 PM | #10 |
Not Yet Wild
Join Date: Jun 2009
Location: Grand Isle Louisiana
Posts: 30
|
Re: New motor and cart wont go
I now have 4 green flashing leds then 6 red flashing leds on controller so i swapped out battery pack and letting them charge overnite thinking i have bad batteries
|
|
|
Similar Threads | ||||
Thread | Forum | |||
2002 club car FE290cc motor just wont run | Gas Club Car | |||
Motor sounds like it's spinning but cart wont move | Columbia ParCar | |||
1995 36 volt club car motor wont run | Electric Club Car | |||
Motor turns but wont go! | Electric Club Car | |||
91 2-Stroke EZ GO Motor Rebuild Wont Start | Gas EZGO |