EZGO Body Bad Shape

schley_cat_65

I am a newbie to this forum, but i need to know an answer to a question i have.... See i have a 1992 EZGO Marthon, the body is in terrible shape, but it runs extremely well and it has brand new batteries... I have a friend who has a Club Car with the Square Body on it, (So its an older one like my EZGO). His does have a good body but nothing electrical works on the cart, it goes in reverse then magically slams into forward no matter what controller he uses... he is going to build a trailer out of the frame and is taking the body off... the question is this:
Will the Club Car Body Work On My EZGO marathon?

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

kab69440

There's nothing under the sun that CAN'T be done. (with the singular exception of time travel) It will not be a simple drop on & bolt down operation, I am guessing though...

honda_400ex

where you located at?

schley_cat_65

south east ga coast

chloe

The plastic body of the next generation EZGO will fit. If I understand correctly, the cow is a bolt on and the rear section takes some modification and manipulation. Going that way will make it look as though you have a newer cart. The bodies are readily available and very cheap.

schley_cat_65

so its a no go on the club car body? where could i find a body ha;f way cheap? when i replace the body will i have to replace anything like the cup holders and radio insert ?

chloe

The plastic body of the next generation EZGO will fit. If I understand correctly, the cow is a bolt on and the rear section takes some modification and manipulation. Going that way will make it look as though you have a newer cart. The bodies are readily available and very cheap.

gornoman

A TXT plastic body will not fit a Marathon easily. It will fit a Medalist directly.

chloe

Thanks for correcting me Gornoman. I'll lknow better next time.


Bad enough to be wrong, but to be wrong and double post it!!!!!! Does that make me doubly wrong?

pachanga90

The TXT body will fit with a little fab-work.You need to remove everything from the cowl except the foot-well itself.My cart in my-pics is a 85' Marathon with a TxT body.The seat-frame needs to be lowered about 1" or so.Its' pretty straight-forward if you have decent fab-skills.The Club-Car body may work,but I'd do a lot of measuring first.I have pics of the swap if anyone needs copies.Hope this helps.