97' TXT problem...

mikeshotrodshop · 08-19-2008, 06:04 PM

Hello folks,

I'm new to the forum and I have a question maybe one of you can help with an answer.

I have a 97' EZ-GO TXT and sometimes the cart wants to go into reverse when the direction switch is in forward. Now this will happen in either way. It appears the motor is changing polarity until de-energized then all is well. I did remove the diode and double red wire from the bottom of the solenoid as it seemed to have gotten hot at one time or another, but this did not solve the problem. This is an intermittent problem that is become a safety issue when my wife drives the cart with the kids in it.

Any help would be greatly appreciated and if you need more info, please ask and I'll make it happen.

Mike

rusty · 08-19-2008, 07:40 PM

Welcome to the forum mikeshotrodshop................

Thats a weird one. Send all the information you have on this problem. Are there any other problems you have noticed with the cart?

pggroves · 08-19-2008, 08:17 PM

Is it a DCS cart?

mikeshotrodshop · 08-19-2008, 10:13 PM

Thanks for the replies guys,

As far as all of the problems - what it appears to be is: the motor is switching polarity. If you have the cart in forward and hit the accelerator, the cart will reverse. When you remove your foot from the accelerator and reapply the cart will proceed in the direction it was switched to (I hope this is making sense).

Another problem I noticed was the 2-red wires going to the left side terminal of the solenoid got hot at one time and burned some. I removed these wires and the circuit board that has three diodes on it. I thought maybe this was my problem; no such luck.... Since this circuit board has been removed along with the 2-red wires, I have lost regen and motor braking. When you take your foot off the accelerator the cart free wheels with no resistance. Also, it doesn’t seem to have much speed. I do have a 400amp controller and it seems worse than stock or at least the same. I replaced the controller thinking this was the problem with the going in the opposite direction than what it was switched to.

I hope this helps, caus I could use some….

BTW – DCS or PCS, I’m not sure. I do have a run tow switch and the forward reverse switch is in front of the seat, not on the dash.

outback · 08-20-2008, 02:20 PM

I have a 97 TXT, and if his cart is stock, it's likely non-DCS.

Does it look like these:

pggroves · 08-20-2008, 03:01 PM

Quote:

Originally Posted by mikeshotrodshop

BTW – DCS or PCS, I’m not sure. I do have a run tow switch and the forward reverse switch is in front of the seat, not on the dash.

You have a DCS cart.

gornoman · 08-20-2008, 06:07 PM

I agree, the cart is a DCS. If water gets into the F/R switch assembly all sorts of weird things can happen. It's not common, but it does happen.

Is your 400 amp controller aftermarket, or is your cart a Freedom model?

mikeshotrodshop · 08-20-2008, 06:19 PM

Here are some pictures to possibly help:

Relay

Burned wires the I removed from the relay

Diode that was under relay

Motor

Speed controler

Run/tow cover

Accelerator box

You may notice that the cart is apart. I removed everything to paint the frame and the body. It's going to be my new John Deere lifted cart. Kewl Huh! Now if I can only find that little demon that is troubling me..

Please help!!! :0)

mikeshotrodshop · 08-20-2008, 06:24 PM

Quote:

Is your 400 amp controller aftermarket, or is your cart a Freedom model?

The controller is a factory upgraded model from FSIP; it came with the cart. As far as being a freedom model, I have no idea; I'm new to the golf cart scene. However, give me something to look at and I can tell you if it is or not.

Thanks,
Mike

outback · 08-20-2008, 06:46 PM

Nice avitar there Mike. Single shot 300?? Do you hunt with it?

08-19-2008, 06:04 PM	#1
mikeshotrodshop Not Yet Wild Join Date: Aug 2008 Posts: 14	97' TXT problem... Hello folks, I'm new to the forum and I have a question maybe one of you can help with an answer. I have a 97' EZ-GO TXT and sometimes the cart wants to go into reverse when the direction switch is in forward. Now this will happen in either way. It appears the motor is changing polarity until de-energized then all is well. I did remove the diode and double red wire from the bottom of the solenoid as it seemed to have gotten hot at one time or another, but this did not solve the problem. This is an intermittent problem that is become a safety issue when my wife drives the cart with the kids in it. Any help would be greatly appreciated and if you need more info, please ask and I'll make it happen. Mike

08-19-2008, 07:40 PM	#2
rusty The Welcome Guy Join Date: Jan 2007 Location: Wichita Falls Texas - My Rides 1996 E-Z-GO and 2002 Club Car IQ and 2003 Club Car IQ Posts: 2,544	Re: 97' TXT problem... Welcome to the forum mikeshotrodshop................ Thats a weird one. Send all the information you have on this problem. Are there any other problems you have noticed with the cart?

08-19-2008, 08:17 PM	#3
pggroves steeplejack x Join Date: Jan 2007 Location: Republic of Texas Posts: 747	Re: 97' TXT problem... Is it a DCS cart?

08-19-2008, 10:13 PM	#4
mikeshotrodshop Not Yet Wild Join Date: Aug 2008 Posts: 14	Re: 97' TXT problem... Thanks for the replies guys, As far as all of the problems - what it appears to be is: the motor is switching polarity. If you have the cart in forward and hit the accelerator, the cart will reverse. When you remove your foot from the accelerator and reapply the cart will proceed in the direction it was switched to (I hope this is making sense). Another problem I noticed was the 2-red wires going to the left side terminal of the solenoid got hot at one time and burned some. I removed these wires and the circuit board that has three diodes on it. I thought maybe this was my problem; no such luck.... Since this circuit board has been removed along with the 2-red wires, I have lost regen and motor braking. When you take your foot off the accelerator the cart free wheels with no resistance. Also, it doesn’t seem to have much speed. I do have a 400amp controller and it seems worse than stock or at least the same. I replaced the controller thinking this was the problem with the going in the opposite direction than what it was switched to. I hope this helps, caus I could use some…. BTW – DCS or PCS, I’m not sure. I do have a run tow switch and the forward reverse switch is in front of the seat, not on the dash.

08-20-2008, 06:07 PM	#7
gornoman Two Cheeks Sliding Join Date: Jan 2007 Location: Suburban Chicago Posts: 1,751	Re: 97' TXT problem... I agree, the cart is a DCS. If water gets into the F/R switch assembly all sorts of weird things can happen. It's not common, but it does happen. Is your 400 amp controller aftermarket, or is your cart a Freedom model?

08-20-2008, 06:19 PM	#8
mikeshotrodshop Not Yet Wild Join Date: Aug 2008 Posts: 14	Re: 97' TXT problem... Here are some pictures to possibly help: Relay Burned wires the I removed from the relay Diode that was under relay Motor Speed controler Run/tow cover Accelerator box You may notice that the cart is apart. I removed everything to paint the frame and the body. It's going to be my new John Deere lifted cart. Kewl Huh! Now if I can only find that little demon that is troubling me.. Please help!!! :0)

08-20-2008, 06:46 PM	#10
outback Getting Wild Join Date: Jun 2008 Location: Garland, TX Posts: 142	Re: 97' TXT problem... Nice avitar there Mike. Single shot 300?? Do you hunt with it?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Forum
Pds Problem	Electric golf carts
G8 Problem?	Gas Yamaha
G8 Gas Problem Help!	Gas Yamaha
Go Problem	Electric EZGO
need a help with no go problem	Electric Club Car