lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric EZGO
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV.



Post New Thread  Reply
Thread Tools Display Modes
Unread 08-19-2008, 11:24 PM   #1
Not Yet Wild
 
Join Date: Aug 2008
Posts: 2
Default Tallnut412

How Do You Remove The Speed Switch Contact Board,to Replace The Contacts And Replace The Speed Switch Wiper Contact On A 1989 Ez Go Marathon. Your Help Is Needed ..................
TALLNUT412 is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 08-20-2008, 12:28 AM   #2
Golf Cart Photographer
 
rusty's Avatar
Club Car
 
Join Date: Jan 2007
Location: Wichita Falls Texas - My Ride 2010 Club Car
Posts: 6,238
Default Re: Tallnut412

Welcome to the forum TALLNUT412............
rusty is offline   Reply With Quote
Unread 08-20-2008, 07:24 AM   #3
nimda
Club Car
 
Join Date: Jun 2007
Posts: 12,913
Default Re: Tallnut412

Quote:
Originally Posted by TALLNUT412 View Post
How Do You Remove The Speed Switch Contact Board,to Replace The Contacts And Replace The Speed Switch Wiper Contact On A 1989 Ez Go Marathon. Your Help Is Needed ..................
First thing I would do is make sure I have all power disconnected. Label all your connections, use masking tape and draw out a scetch if needed. Then just start unbolting components till you get it out. Its not difficult at all, it just looks spooky.

You "Might" be able to replace one contact at a time without removing the speed board. It depends on whether you can get you hands/tools in there to remove and re-install the contacts.
roady89 is offline   Reply With Quote
Unread 08-20-2008, 09:13 AM   #4
steeplejack x
 
pggroves's Avatar
E-Z-GO
 
Join Date: Jan 2007
Location: Republic of Texas
Posts: 3,337
Default Re: Tallnut412

The wiper arm shaft nut is the only thing holding the board to the mount. Loosen the shaft nut, disconnect the accelerator linkage and the whole assembly will slide up and off.

As roady says, make sure you note where all connections go first and disconnect the battery pack before servicing.

HTH and good luck.
pggroves is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric EZGO


Thread Tools
Display Modes



All times are GMT -5. The time now is 11:50 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.