|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
07-19-2013, 07:08 AM | #1 |
Gone Wild
Join Date: Jan 2011
Location: mascoutah,il
Posts: 387
|
2001 ezgo ????
How do you know if a 2001 ezgo is dcs or pds cart? Just bought 2 and need to rewire. Thanks
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-19-2013, 07:22 AM | #2 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 2001 ezgo ????
Quote:
Enter the cart serial number on this website and it'll tell you what the cart was when it rolled off the assembly line. http://www.shopezgo.com/customer-ser...ialNumber.html |
|
07-19-2013, 09:21 AM | #3 |
Gone Wild
Join Date: Jan 2011
Location: mascoutah,il
Posts: 387
|
Re: 2001 ezgo ????
Thanks johnnie::-p
|
08-19-2013, 09:01 PM | #4 |
Gone Wild
Join Date: Jan 2011
Location: mascoutah,il
Posts: 387
|
Re: 2001 ezgo ????
2001 txt pds system,the cart will go forward for 25 ft and slow down to a crawl. When the cart is on jack stands and the voltage is monitored at the controller the voltage on A1 is at first pack voltage and then drops to 18V. I have replaced the controller and solenoid with good units with the same results. HELP PLEASE! What to check next? Thanks
|
08-19-2013, 09:13 PM | #5 |
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,146
|
Re: 2001 ezgo ????
Sounds like the speed sensor. Is it beeping when it slows? To test, with cart in F, key on and brake released, push the cart and it should start beeping and try to stop itself.
|
08-20-2013, 10:47 AM | #6 |
Gone Wild
Join Date: Jan 2011
Location: mascoutah,il
Posts: 387
|
Re: 2001 ezgo ????
I have check all wiring with another 2001 txt that works,All wiring is correct. How do I check the throttle sensor?
|
08-20-2013, 11:31 AM | #7 |
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,146
|
Re: 2001 ezgo ????
Test the speed sensor. Don't think it is the throttle sensor. If you have a working cart you can swap parts with, the speed sensor is in the drivers side end of the motor with a grey wire coming out. It is held in with a split ring. Other end is on top of the controller. Make sure to flip the Run/Tow switch to Tow before you start removing wires.
|
08-21-2013, 10:34 AM | #8 |
Gone Wild
Join Date: Jan 2011
Location: mascoutah,il
Posts: 387
|
Re: 2001 ezgo ????
The good cart when pushed does beep,the bad cart when pushed does not beep. Is this a sure diagnosis of a bad speed sensor or should I do some voltage test?
|
08-21-2013, 11:36 AM | #9 |
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,146
|
Re: 2001 ezgo ????
Does the bad cart beep when you put it in reverse ? If yes, it is either a bad speed sensor or wires to it. Make sure the contacts are clean on top if the controller OR it is a bad controller. IMO. If you had one to test it with it would make it definite..
|
08-21-2013, 11:51 AM | #10 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 2001 ezgo ????
Quote:
You can check to see if you've got voltage between Pins 1 & 3 (Black and Red wires) on J5 with plug plugged in, but other than that you need something to detect the pulses the speed sensor puts out. I have an automotive DMM with a tachometer function and I have measured motor RPM off pins 1 & 2 (White wire is the output of the Hall Effect device), but I'm not sure if you'd see anything with a straight voltmeter looking at pin-2. You said the cart would move a little ways before it slowed to a crawl. That sounds like the magnet disk may be loose on the motor shaft and is slipping. The speed sensor is held in place with a snap ring. Remove the snap ring and the sensor will come out. The is a second snap ring that positions the sensor above the magnet ring, but you can tighten the screw that hold the magnet ring in place without removing the second snap ring. If the screw is loose, tightening it so the magnetic disk doesn't slip will probably fix the problem. |
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Is my EZGO an early 2001 or a 2001.5+? | Gas EZGO | |||
My first 2001 ezgo | Members Rides | |||
2001 ezgo gas | Gas EZGO |