just got an 94 ezgo 36 volt

bearfoot1

picked this up needed batteries put in batteries and wont move reverse noise is there when you put it in reverse looks like has a new controller I don't have any test equipment but looking at a 96 wireing diagram its wired wrong but mine is a 94 are they the same????

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

kgsc

You need a voltmeter. Which drive system is this cart ? If it is a 94 I would assume series so it would have the shifter by your right leg and a rod coming from it to a box on the passenger side. As for wiring, it depends on what type of cart the 96 is. If they are both series they should be the same

JohnnieB

It should be one of the two attached schematics.
They are electrically the same except for the "Ignition Interlock" (aka Reed Switch) in the upper left corner.

Attached Images

	Medalist Series - No Reed Switch - Schematic.JPG (72.4 KB, 0 views)
	Medalist Series schematic.JPG (119.2 KB, 0 views)

bearfoot1

yes it is

bearfoot1

mine has a solenoid I don't see one on the diagram?

bearfoot1

never mind I see it now the other diagram I have looks more like my system

its called solid state speed control version page n-6 EZ-GO textron

JohnnieB

Perhaps, we should first identify which of the half dozen or so different models and drive train combinations EZGO produced in 1994, then figure out which is the correct schematic for it.

If you can find the serial number, entry it on the linked site and it will tell you what it was when it rolled off the assembly line.
http://www.shopezgo.com/customer-ser...ialNumber.html

bearfoot1

Got it its a 94 - 36v medalist

bearfoot1

Trying to do some research on here I don't know if this will help but with everything wired right as far as I can tell when you hit the accelarator pedal nothing happens no click from selonoid or anythinhi am at the campground where I bought it said needs new batterys put them in and new cables. Likfe I said it beeps when put in reverse but nothing else I brought a volt meter here with me today but it must have a blown fuse I can't get any readings even of my truck which runs fine.

shaffer88

You need a digital volt meter. . No click may be bad solenoid but before you go replacing things a Dvm will tell you if it is bad